diff options
Diffstat (limited to 'drivers/net/wireless/ath/ath5k/reset.c')
| -rw-r--r-- | drivers/net/wireless/ath/ath5k/reset.c | 155 |
1 files changed, 115 insertions, 40 deletions
diff --git a/drivers/net/wireless/ath/ath5k/reset.c b/drivers/net/wireless/ath/ath5k/reset.c index bd0a97a38d34..4980621b0239 100644 --- a/drivers/net/wireless/ath/ath5k/reset.c +++ b/drivers/net/wireless/ath/ath5k/reset.c @@ -258,29 +258,35 @@ int ath5k_hw_set_power(struct ath5k_hw *ah, enum ath5k_power_mode mode, if (!set_chip) goto commit; - /* Preserve sleep duration */ data = ath5k_hw_reg_read(ah, AR5K_SLEEP_CTL); + + /* If card is down we 'll get 0xffff... so we + * need to clean this up before we write the register + */ if (data & 0xffc00000) data = 0; else - data = data & 0xfffcffff; + /* Preserve sleep duration etc */ + data = data & ~AR5K_SLEEP_CTL_SLE; - ath5k_hw_reg_write(ah, data, AR5K_SLEEP_CTL); + ath5k_hw_reg_write(ah, data | AR5K_SLEEP_CTL_SLE_WAKE, + AR5K_SLEEP_CTL); udelay(15); - for (i = 50; i > 0; i--) { + for (i = 200; i > 0; i--) { /* Check if the chip did wake up */ if ((ath5k_hw_reg_read(ah, AR5K_PCICFG) & AR5K_PCICFG_SPWR_DN) == 0) break; /* Wait a bit and retry */ - udelay(200); - ath5k_hw_reg_write(ah, data, AR5K_SLEEP_CTL); + udelay(50); + ath5k_hw_reg_write(ah, data | AR5K_SLEEP_CTL_SLE_WAKE, + AR5K_SLEEP_CTL); } /* Fail if the chip didn't wake up */ - if (i <= 0) + if (i == 0) return -EIO; break; @@ -297,6 +303,64 @@ commit: } /* + * Put device on hold + * + * Put MAC and Baseband on warm reset and + * keep that state (don't clean sleep control + * register). After this MAC and Baseband are + * disabled and a full reset is needed to come + * back. This way we save as much power as possible + * without puting the card on full sleep. + */ +int ath5k_hw_on_hold(struct ath5k_hw *ah) +{ + struct pci_dev *pdev = ah->ah_sc->pdev; + u32 bus_flags; + int ret; + + /* Make sure device is awake */ + ret = ath5k_hw_set_power(ah, AR5K_PM_AWAKE, true, 0); + if (ret) { + ATH5K_ERR(ah->ah_sc, "failed to wakeup the MAC Chip\n"); + return ret; + } + + /* + * Put chipset on warm reset... + * + * Note: puting PCI core on warm reset on PCI-E cards + * results card to hang and always return 0xffff... so + * we ingore that flag for PCI-E cards. On PCI cards + * this flag gets cleared after 64 PCI clocks. + */ + bus_flags = (pdev->is_pcie) ? 0 : AR5K_RESET_CTL_PCI; + + if (ah->ah_version == AR5K_AR5210) { + ret = ath5k_hw_nic_reset(ah, AR5K_RESET_CTL_PCU | + AR5K_RESET_CTL_MAC | AR5K_RESET_CTL_DMA | + AR5K_RESET_CTL_PHY | AR5K_RESET_CTL_PCI); + mdelay(2); + } else { + ret = ath5k_hw_nic_reset(ah, AR5K_RESET_CTL_PCU | + AR5K_RESET_CTL_BASEBAND | bus_flags); + } + + if (ret) { + ATH5K_ERR(ah->ah_sc, "failed to put device on warm reset\n"); + return -EIO; + } + + /* ...wakeup again!*/ + ret = ath5k_hw_set_power(ah, AR5K_PM_AWAKE, true, 0); + if (ret) { + ATH5K_ERR(ah->ah_sc, "failed to put device on hold\n"); + return ret; + } + + return ret; +} + +/* * Bring up MAC + PHY Chips and program PLL * TODO: Half/Quarter rate support */ @@ -319,6 +383,50 @@ int ath5k_hw_nic_wakeup(struct ath5k_hw *ah, int flags, bool initial) return ret; } + /* + * Put chipset on warm reset... + * + * Note: puting PCI core on warm reset on PCI-E cards + * results card to hang and always return 0xffff... so + * we ingore that flag for PCI-E cards. On PCI cards + * this flag gets cleared after 64 PCI clocks. + */ + bus_flags = (pdev->is_pcie) ? 0 : AR5K_RESET_CTL_PCI; + + if (ah->ah_version == AR5K_AR5210) { + ret = ath5k_hw_nic_reset(ah, AR5K_RESET_CTL_PCU | + AR5K_RESET_CTL_MAC | AR5K_RESET_CTL_DMA | + AR5K_RESET_CTL_PHY | AR5K_RESET_CTL_PCI); + mdelay(2); + } else { + ret = ath5k_hw_nic_reset(ah, AR5K_RESET_CTL_PCU | + AR5K_RESET_CTL_BASEBAND | bus_flags); + } + + if (ret) { + ATH5K_ERR(ah->ah_sc, "failed to reset the MAC Chip\n"); + return -EIO; + } + + /* ...wakeup again!...*/ + ret = ath5k_hw_set_power(ah, AR5K_PM_AWAKE, true, 0); + if (ret) { + ATH5K_ERR(ah->ah_sc, "failed to resume the MAC Chip\n"); + return ret; + } + + /* ...clear reset control register and pull device out of + * warm reset */ + if (ath5k_hw_nic_reset(ah, 0)) { + ATH5K_ERR(ah->ah_sc, "failed to warm reset the MAC Chip\n"); + return -EIO; + } + + /* On initialization skip PLL programming since we don't have + * a channel / mode set yet */ + if (initial) + return 0; + if (ah->ah_version != AR5K_AR5210) { /* * Get channel mode flags @@ -384,39 +492,6 @@ int ath5k_hw_nic_wakeup(struct ath5k_hw *ah, int flags, bool initial) AR5K_PHY_TURBO); } - /* reseting PCI on PCI-E cards results card to hang - * and always return 0xffff... so we ingore that flag - * for PCI-E cards */ - bus_flags = (pdev->is_pcie) ? 0 : AR5K_RESET_CTL_PCI; - - /* Reset chipset */ - if (ah->ah_version == AR5K_AR5210) { - ret = ath5k_hw_nic_reset(ah, AR5K_RESET_CTL_PCU | - AR5K_RESET_CTL_MAC | AR5K_RESET_CTL_DMA | - AR5K_RESET_CTL_PHY | AR5K_RESET_CTL_PCI); - mdelay(2); - } else { - ret = ath5k_hw_nic_reset(ah, AR5K_RESET_CTL_PCU | - AR5K_RESET_CTL_BASEBAND | bus_flags); - } - if (ret) { - ATH5K_ERR(ah->ah_sc, "failed to reset the MAC Chip\n"); - return -EIO; - } - - /* ...wakeup again!*/ - ret = ath5k_hw_set_power(ah, AR5K_PM_AWAKE, true, 0); - if (ret) { - ATH5K_ERR(ah->ah_sc, "failed to resume the MAC Chip\n"); - return ret; - } - - /* ...final warm reset */ - if (ath5k_hw_nic_reset(ah, 0)) { - ATH5K_ERR(ah->ah_sc, "failed to warm reset the MAC Chip\n"); - return -EIO; - } - if (ah->ah_version != AR5K_AR5210) { /* ...update PLL if needed */ |