diff options
Diffstat (limited to 'drivers/tty/serial/sc16is7xx.c')
| -rw-r--r-- | drivers/tty/serial/sc16is7xx.c | 17 |
1 files changed, 16 insertions, 1 deletions
diff --git a/drivers/tty/serial/sc16is7xx.c b/drivers/tty/serial/sc16is7xx.c index b57cf8ddbf63..e8f8a94ad606 100644 --- a/drivers/tty/serial/sc16is7xx.c +++ b/drivers/tty/serial/sc16is7xx.c @@ -1170,9 +1170,18 @@ static int sc16is7xx_gpio_direction_output(struct gpio_chip *chip, state |= BIT(offset); else state &= ~BIT(offset); - sc16is7xx_port_write(port, SC16IS7XX_IOSTATE_REG, state); + + /* + * If we write IOSTATE first, and then IODIR, the output value is not + * transferred to the corresponding I/O pin. + * The datasheet states that each register bit will be transferred to + * the corresponding I/O pin programmed as output when writing to + * IOSTATE. Therefore, configure direction first with IODIR, and then + * set value after with IOSTATE. + */ sc16is7xx_port_update(port, SC16IS7XX_IODIR_REG, BIT(offset), BIT(offset)); + sc16is7xx_port_write(port, SC16IS7XX_IOSTATE_REG, state); return 0; } @@ -1258,6 +1267,12 @@ static int sc16is7xx_probe(struct device *dev, s->p[i].port.fifosize = SC16IS7XX_FIFO_SIZE; s->p[i].port.flags = UPF_FIXED_TYPE | UPF_LOW_LATENCY; s->p[i].port.iobase = i; + /* + * Use all ones as membase to make sure uart_configure_port() in + * serial_core.c does not abort for SPI/I2C devices where the + * membase address is not applicable. + */ + s->p[i].port.membase = (void __iomem *)~0; s->p[i].port.iotype = UPIO_PORT; s->p[i].port.uartclk = freq; s->p[i].port.rs485_config = sc16is7xx_config_rs485; |