summaryrefslogtreecommitdiff
path: root/drivers/usb/host
diff options
context:
space:
mode:
Diffstat (limited to 'drivers/usb/host')
-rw-r--r--drivers/usb/host/xhci-mem.c17
-rw-r--r--drivers/usb/host/xhci-pci.c90
-rw-r--r--drivers/usb/host/xhci-ring.c13
-rw-r--r--drivers/usb/host/xhci.c24
4 files changed, 75 insertions, 69 deletions
diff --git a/drivers/usb/host/xhci-mem.c b/drivers/usb/host/xhci-mem.c
index 9a8c936cd42c..41f841fa6c4d 100644
--- a/drivers/usb/host/xhci-mem.c
+++ b/drivers/usb/host/xhci-mem.c
@@ -1498,10 +1498,10 @@ int xhci_endpoint_init(struct xhci_hcd *xhci,
* use Event Data TRBs, and we don't chain in a link TRB on short
* transfers, we're basically dividing by 1.
*
- * xHCI 1.0 specification indicates that the Average TRB Length should
- * be set to 8 for control endpoints.
+ * xHCI 1.0 and 1.1 specification indicates that the Average TRB Length
+ * should be set to 8 for control endpoints.
*/
- if (usb_endpoint_xfer_control(&ep->desc) && xhci->hci_version == 0x100)
+ if (usb_endpoint_xfer_control(&ep->desc) && xhci->hci_version >= 0x100)
ep_ctx->tx_info |= cpu_to_le32(AVG_TRB_LENGTH_FOR_EP(8));
else
ep_ctx->tx_info |=
@@ -1792,8 +1792,7 @@ void xhci_mem_cleanup(struct xhci_hcd *xhci)
int size;
int i, j, num_ports;
- if (timer_pending(&xhci->cmd_timer))
- del_timer_sync(&xhci->cmd_timer);
+ del_timer_sync(&xhci->cmd_timer);
/* Free the Event Ring Segment Table and the actual Event Ring */
size = sizeof(struct xhci_erst_entry)*(xhci->erst.num_entries);
@@ -2321,6 +2320,10 @@ int xhci_mem_init(struct xhci_hcd *xhci, gfp_t flags)
INIT_LIST_HEAD(&xhci->cmd_list);
+ /* init command timeout timer */
+ setup_timer(&xhci->cmd_timer, xhci_handle_command_timeout,
+ (unsigned long)xhci);
+
page_size = readl(&xhci->op_regs->page_size);
xhci_dbg_trace(xhci, trace_xhci_dbg_init,
"Supported page size register = 0x%x", page_size);
@@ -2505,10 +2508,6 @@ int xhci_mem_init(struct xhci_hcd *xhci, gfp_t flags)
"Wrote ERST address to ir_set 0.");
xhci_print_ir_set(xhci, 0);
- /* init command timeout timer */
- setup_timer(&xhci->cmd_timer, xhci_handle_command_timeout,
- (unsigned long)xhci);
-
/*
* XXX: Might need to set the Interrupter Moderation Register to
* something other than the default (~1ms minimum between interrupts).
diff --git a/drivers/usb/host/xhci-pci.c b/drivers/usb/host/xhci-pci.c
index 5590eac2b22d..c79d33676672 100644
--- a/drivers/usb/host/xhci-pci.c
+++ b/drivers/usb/host/xhci-pci.c
@@ -180,51 +180,6 @@ static void xhci_pci_quirks(struct device *dev, struct xhci_hcd *xhci)
"QUIRK: Resetting on resume");
}
-/*
- * In some Intel xHCI controllers, in order to get D3 working,
- * through a vendor specific SSIC CONFIG register at offset 0x883c,
- * SSIC PORT need to be marked as "unused" before putting xHCI
- * into D3. After D3 exit, the SSIC port need to be marked as "used".
- * Without this change, xHCI might not enter D3 state.
- * Make sure PME works on some Intel xHCI controllers by writing 1 to clear
- * the Internal PME flag bit in vendor specific PMCTRL register at offset 0x80a4
- */
-static void xhci_pme_quirk(struct usb_hcd *hcd, bool suspend)
-{
- struct xhci_hcd *xhci = hcd_to_xhci(hcd);
- struct pci_dev *pdev = to_pci_dev(hcd->self.controller);
- u32 val;
- void __iomem *reg;
-
- if (pdev->vendor == PCI_VENDOR_ID_INTEL &&
- pdev->device == PCI_DEVICE_ID_INTEL_CHERRYVIEW_XHCI) {
-
- reg = (void __iomem *) xhci->cap_regs + PORT2_SSIC_CONFIG_REG2;
-
- /* Notify SSIC that SSIC profile programming is not done */
- val = readl(reg) & ~PROG_DONE;
- writel(val, reg);
-
- /* Mark SSIC port as unused(suspend) or used(resume) */
- val = readl(reg);
- if (suspend)
- val |= SSIC_PORT_UNUSED;
- else
- val &= ~SSIC_PORT_UNUSED;
- writel(val, reg);
-
- /* Notify SSIC that SSIC profile programming is done */
- val = readl(reg) | PROG_DONE;
- writel(val, reg);
- readl(reg);
- }
-
- reg = (void __iomem *) xhci->cap_regs + 0x80a4;
- val = readl(reg);
- writel(val | BIT(28), reg);
- readl(reg);
-}
-
#ifdef CONFIG_ACPI
static void xhci_pme_acpi_rtd3_enable(struct pci_dev *dev)
{
@@ -345,6 +300,51 @@ static void xhci_pci_remove(struct pci_dev *dev)
}
#ifdef CONFIG_PM
+/*
+ * In some Intel xHCI controllers, in order to get D3 working,
+ * through a vendor specific SSIC CONFIG register at offset 0x883c,
+ * SSIC PORT need to be marked as "unused" before putting xHCI
+ * into D3. After D3 exit, the SSIC port need to be marked as "used".
+ * Without this change, xHCI might not enter D3 state.
+ * Make sure PME works on some Intel xHCI controllers by writing 1 to clear
+ * the Internal PME flag bit in vendor specific PMCTRL register at offset 0x80a4
+ */
+static void xhci_pme_quirk(struct usb_hcd *hcd, bool suspend)
+{
+ struct xhci_hcd *xhci = hcd_to_xhci(hcd);
+ struct pci_dev *pdev = to_pci_dev(hcd->self.controller);
+ u32 val;
+ void __iomem *reg;
+
+ if (pdev->vendor == PCI_VENDOR_ID_INTEL &&
+ pdev->device == PCI_DEVICE_ID_INTEL_CHERRYVIEW_XHCI) {
+
+ reg = (void __iomem *) xhci->cap_regs + PORT2_SSIC_CONFIG_REG2;
+
+ /* Notify SSIC that SSIC profile programming is not done */
+ val = readl(reg) & ~PROG_DONE;
+ writel(val, reg);
+
+ /* Mark SSIC port as unused(suspend) or used(resume) */
+ val = readl(reg);
+ if (suspend)
+ val |= SSIC_PORT_UNUSED;
+ else
+ val &= ~SSIC_PORT_UNUSED;
+ writel(val, reg);
+
+ /* Notify SSIC that SSIC profile programming is done */
+ val = readl(reg) | PROG_DONE;
+ writel(val, reg);
+ readl(reg);
+ }
+
+ reg = (void __iomem *) xhci->cap_regs + 0x80a4;
+ val = readl(reg);
+ writel(val | BIT(28), reg);
+ readl(reg);
+}
+
static int xhci_pci_suspend(struct usb_hcd *hcd, bool do_wakeup)
{
struct xhci_hcd *xhci = hcd_to_xhci(hcd);
diff --git a/drivers/usb/host/xhci-ring.c b/drivers/usb/host/xhci-ring.c
index a47a1e897086..43291f93afeb 100644
--- a/drivers/usb/host/xhci-ring.c
+++ b/drivers/usb/host/xhci-ring.c
@@ -302,6 +302,15 @@ static int xhci_abort_cmd_ring(struct xhci_hcd *xhci)
ret = xhci_handshake(&xhci->op_regs->cmd_ring,
CMD_RING_RUNNING, 0, 5 * 1000 * 1000);
if (ret < 0) {
+ /* we are about to kill xhci, give it one more chance */
+ xhci_write_64(xhci, temp_64 | CMD_RING_ABORT,
+ &xhci->op_regs->cmd_ring);
+ udelay(1000);
+ ret = xhci_handshake(&xhci->op_regs->cmd_ring,
+ CMD_RING_RUNNING, 0, 3 * 1000 * 1000);
+ if (ret == 0)
+ return 0;
+
xhci_err(xhci, "Stopped the command ring failed, "
"maybe the host is dead\n");
xhci->xhc_state |= XHCI_STATE_DYING;
@@ -3461,8 +3470,8 @@ int xhci_queue_ctrl_tx(struct xhci_hcd *xhci, gfp_t mem_flags,
if (start_cycle == 0)
field |= 0x1;
- /* xHCI 1.0 6.4.1.2.1: Transfer Type field */
- if (xhci->hci_version == 0x100) {
+ /* xHCI 1.0/1.1 6.4.1.2.1: Transfer Type field */
+ if (xhci->hci_version >= 0x100) {
if (urb->transfer_buffer_length > 0) {
if (setup->bRequestType & USB_DIR_IN)
field |= TRB_TX_TYPE(TRB_DATA_IN);
diff --git a/drivers/usb/host/xhci.c b/drivers/usb/host/xhci.c
index 6b0f4a47e402..9957bd96d4bc 100644
--- a/drivers/usb/host/xhci.c
+++ b/drivers/usb/host/xhci.c
@@ -146,7 +146,8 @@ static int xhci_start(struct xhci_hcd *xhci)
"waited %u microseconds.\n",
XHCI_MAX_HALT_USEC);
if (!ret)
- xhci->xhc_state &= ~XHCI_STATE_HALTED;
+ xhci->xhc_state &= ~(XHCI_STATE_HALTED | XHCI_STATE_DYING);
+
return ret;
}
@@ -654,15 +655,6 @@ int xhci_run(struct usb_hcd *hcd)
}
EXPORT_SYMBOL_GPL(xhci_run);
-static void xhci_only_stop_hcd(struct usb_hcd *hcd)
-{
- struct xhci_hcd *xhci = hcd_to_xhci(hcd);
-
- spin_lock_irq(&xhci->lock);
- xhci_halt(xhci);
- spin_unlock_irq(&xhci->lock);
-}
-
/*
* Stop xHCI driver.
*
@@ -677,12 +669,14 @@ void xhci_stop(struct usb_hcd *hcd)
u32 temp;
struct xhci_hcd *xhci = hcd_to_xhci(hcd);
- if (!usb_hcd_is_primary_hcd(hcd)) {
- xhci_only_stop_hcd(xhci->shared_hcd);
+ if (xhci->xhc_state & XHCI_STATE_HALTED)
return;
- }
+ mutex_lock(&xhci->mutex);
spin_lock_irq(&xhci->lock);
+ xhci->xhc_state |= XHCI_STATE_HALTED;
+ xhci->cmd_ring_state = CMD_RING_STATE_STOPPED;
+
/* Make sure the xHC is halted for a USB3 roothub
* (xhci_stop() could be called as part of failed init).
*/
@@ -717,6 +711,7 @@ void xhci_stop(struct usb_hcd *hcd)
xhci_dbg_trace(xhci, trace_xhci_dbg_init,
"xhci_stop completed - status = %x",
readl(&xhci->op_regs->status));
+ mutex_unlock(&xhci->mutex);
}
/*
@@ -3793,6 +3788,9 @@ static int xhci_setup_device(struct usb_hcd *hcd, struct usb_device *udev,
mutex_lock(&xhci->mutex);
+ if (xhci->xhc_state) /* dying or halted */
+ goto out;
+
if (!udev->slot_id) {
xhci_dbg_trace(xhci, trace_xhci_dbg_address,
"Bad Slot ID %d", udev->slot_id);
generated by cgit v1.2.3 (git 2.0.4) at 2024-11-09 00:28:22 +0000