diff options
Diffstat (limited to 'include/linux/pinctrl/pinconf-generic.h')
| -rw-r--r-- | include/linux/pinctrl/pinconf-generic.h | 17 |
1 files changed, 15 insertions, 2 deletions
diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h index 4f0abb9f1c09..72474e18f1e0 100644 --- a/include/linux/pinctrl/pinconf-generic.h +++ b/include/linux/pinctrl/pinconf-generic.h @@ -46,11 +46,15 @@ * @PIN_CONFIG_DRIVE_OPEN_SOURCE: the pin will be driven with open source * (open emitter). Sending this config will enabale open drain mode, the * argument is ignored. + * @PIN_CONFIG_DRIVE_STRENGTH: the pin will output the current passed as + * argument. The argument is in mA. + * @PIN_CONFIG_INPUT_SCHMITT_ENABLE: control schmitt-trigger mode on the pin. + * If the argument != 0, schmitt-trigger mode is enabled. If it's 0, + * schmitt-trigger mode is disabled. * @PIN_CONFIG_INPUT_SCHMITT: this will configure an input pin to run in * schmitt-trigger mode. If the schmitt-trigger has adjustable hysteresis, * the threshold value is given on a custom format as argument when - * setting pins to this mode. The argument zero turns the schmitt trigger - * off. + * setting pins to this mode. * @PIN_CONFIG_INPUT_DEBOUNCE: this will configure the pin to debounce mode, * which means it will wait for signals to settle when reading inputs. The * argument gives the debounce time on a custom format. Setting the @@ -58,10 +62,15 @@ * @PIN_CONFIG_POWER_SOURCE: if the pin can select between different power * supplies, the argument to this parameter (on a custom format) tells * the driver which alternative power source to use. + * @PIN_CONFIG_SLEW_RATE: if the pin can select slew rate, the argument to + * this parameter (on a custom format) tells the driver which alternative + * slew rate to use. * @PIN_CONFIG_LOW_POWER_MODE: this will configure the pin for low power * operation, if several modes of operation are supported these can be * passed in the argument on a custom form, else just use argument 1 * to indicate low power mode, argument 0 turns low power mode off. + * @PIN_CONFIG_OUTPUT: this will configure the pin in output, use argument + * 1 to indicate high level, argument 0 to indicate low level. * @PIN_CONFIG_END: this is the last enumerator for pin configurations, if * you need to pass in custom configurations to the pin controller, use * PIN_CONFIG_END+1 as the base offset. @@ -74,10 +83,14 @@ enum pin_config_param { PIN_CONFIG_DRIVE_PUSH_PULL, PIN_CONFIG_DRIVE_OPEN_DRAIN, PIN_CONFIG_DRIVE_OPEN_SOURCE, + PIN_CONFIG_DRIVE_STRENGTH, + PIN_CONFIG_INPUT_SCHMITT_ENABLE, PIN_CONFIG_INPUT_SCHMITT, PIN_CONFIG_INPUT_DEBOUNCE, PIN_CONFIG_POWER_SOURCE, + PIN_CONFIG_SLEW_RATE, PIN_CONFIG_LOW_POWER_MODE, + PIN_CONFIG_OUTPUT, PIN_CONFIG_END = 0x7FFF, }; |