diff options
Diffstat (limited to 'include/net/mac80211.h')
| -rw-r--r-- | include/net/mac80211.h | 49 |
1 files changed, 39 insertions, 10 deletions
diff --git a/include/net/mac80211.h b/include/net/mac80211.h index bfc569498bfa..82045fca388b 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -5,6 +5,7 @@ * Copyright 2006-2007 Jiri Benc <jbenc@suse.cz> * Copyright 2007-2010 Johannes Berg <johannes@sipsolutions.net> * Copyright 2013-2014 Intel Mobile Communications GmbH + * Copyright (C) 2015 Intel Deutschland GmbH * * This program is free software; you can redistribute it and/or modify * it under the terms of the GNU General Public License version 2 as @@ -481,7 +482,9 @@ struct ieee80211_event { * Note that with TDLS this can be the case (channel is HT, protection must * be used from this field) even when the BSS association isn't using HT. * @cqm_rssi_thold: Connection quality monitor RSSI threshold, a zero value - * implies disabled + * implies disabled. As with the cfg80211 callback, a change here should + * cause an event to be sent indicating where the current value is in + * relation to the newly configured threshold. * @cqm_rssi_hyst: Connection quality monitor RSSI hysteresis * @arp_addr_list: List of IPv4 addresses for hardware ARP filtering. The * may filter ARP queries targeted for other addresses than listed here. @@ -1240,11 +1243,6 @@ enum ieee80211_smps_mode { * @flags: configuration flags defined above * * @listen_interval: listen interval in units of beacon interval - * @max_sleep_period: the maximum number of beacon intervals to sleep for - * before checking the beacon for a TIM bit (managed mode only); this - * value will be only achievable between DTIM frames, the hardware - * needs to check for the multicast traffic bit in DTIM beacons. - * This variable is valid only when the CONF_PS flag is set. * @ps_dtim_period: The DTIM period of the AP we're connected to, for use * in power saving. Power saving will not be enabled until a beacon * has been received and the DTIM period is known. @@ -1274,7 +1272,6 @@ enum ieee80211_smps_mode { struct ieee80211_conf { u32 flags; int power_level, dynamic_ps_timeout; - int max_sleep_period; u16 listen_interval; u8 ps_dtim_period; @@ -1360,6 +1357,8 @@ enum ieee80211_vif_flags { * @debugfs_dir: debugfs dentry, can be used by drivers to create own per * interface debug files. Note that it will be NULL for the virtual * monitor interface (if that is requested.) + * @probe_req_reg: probe requests should be reported to mac80211 for this + * interface. * @drv_priv: data area for driver use, will always be aligned to * sizeof(void *). * @txq: the multicast data TX queue (if driver uses the TXQ abstraction) @@ -1384,6 +1383,8 @@ struct ieee80211_vif { struct dentry *debugfs_dir; #endif + unsigned int probe_req_reg; + /* must be last */ u8 drv_priv[0] __aligned(sizeof(void *)); }; @@ -1494,10 +1495,8 @@ enum ieee80211_key_flags { * - Temporal Authenticator Rx MIC Key (64 bits) * @icv_len: The ICV length for this key type * @iv_len: The IV length for this key type - * @drv_priv: pointer for driver use */ struct ieee80211_key_conf { - void *drv_priv; atomic64_t tx_pn; u32 cipher; u8 icv_len; @@ -1680,6 +1679,7 @@ struct ieee80211_sta_rates { * @tdls: indicates whether the STA is a TDLS peer * @tdls_initiator: indicates the STA is an initiator of the TDLS link. Only * valid if the STA is a TDLS peer in the first place. + * @mfp: indicates whether the STA uses management frame protection or not. * @txq: per-TID data TX queues (if driver uses the TXQ abstraction) */ struct ieee80211_sta { @@ -1697,6 +1697,7 @@ struct ieee80211_sta { struct ieee80211_sta_rates __rcu *rates; bool tdls; bool tdls_initiator; + bool mfp; struct ieee80211_txq *txq[IEEE80211_NUM_TIDS]; @@ -1894,6 +1895,12 @@ struct ieee80211_txq { * @IEEE80211_HW_TDLS_WIDER_BW: The device/driver supports wider bandwidth * than then BSS bandwidth for a TDLS link on the base channel. * + * @IEEE80211_HW_SUPPORTS_AMSDU_IN_AMPDU: The driver supports receiving A-MSDUs + * within A-MPDU. + * + * @IEEE80211_HW_BEACON_TX_STATUS: The device/driver provides TX status + * for sent beacons. + * * @NUM_IEEE80211_HW_FLAGS: number of hardware flags, used for sizing arrays */ enum ieee80211_hw_flags { @@ -1927,6 +1934,8 @@ enum ieee80211_hw_flags { IEEE80211_HW_SUPPORTS_CLONED_SKBS, IEEE80211_HW_SINGLE_SCAN_ON_ALL_BANDS, IEEE80211_HW_TDLS_WIDER_BW, + IEEE80211_HW_SUPPORTS_AMSDU_IN_AMPDU, + IEEE80211_HW_BEACON_TX_STATUS, /* keep last, obviously */ NUM_IEEE80211_HW_FLAGS @@ -2827,6 +2836,13 @@ enum ieee80211_reconfig_type { * See the section "Frame filtering" for more information. * This callback must be implemented and can sleep. * + * @config_iface_filter: Configure the interface's RX filter. + * This callback is optional and is used to configure which frames + * should be passed to mac80211. The filter_flags is the combination + * of FIF_* flags. The changed_flags is a bit mask that indicates + * which flags are changed. + * This callback can sleep. + * * @set_tim: Set TIM bit. mac80211 calls this function when a TIM bit * must be set or cleared for a given STA. Must be atomic. * @@ -3016,6 +3032,9 @@ enum ieee80211_reconfig_type { * buffer size of 8. Correct ways to retransmit #1 would be: * - TX: 1 or 18 or 81 * Even "189" would be wrong since 1 could be lost again. + * The @amsdu parameter is valid when the action is set to + * %IEEE80211_AMPDU_TX_OPERATIONAL and indicates the peer's ability + * to receive A-MSDU within A-MPDU. * * Returns a negative error code on failure. * The callback can sleep. @@ -3153,18 +3172,24 @@ enum ieee80211_reconfig_type { * The callback is optional and can sleep. * * @add_chanctx: Notifies device driver about new channel context creation. + * This callback may sleep. * @remove_chanctx: Notifies device driver about channel context destruction. + * This callback may sleep. * @change_chanctx: Notifies device driver about channel context changes that * may happen when combining different virtual interfaces on the same * channel context with different settings + * This callback may sleep. * @assign_vif_chanctx: Notifies device driver about channel context being bound * to vif. Possible use is for hw queue remapping. + * This callback may sleep. * @unassign_vif_chanctx: Notifies device driver about channel context being * unbound from vif. + * This callback may sleep. * @switch_vif_chanctx: switch a number of vifs from one chanctx to * another, as specified in the list of * @ieee80211_vif_chanctx_switch passed to the driver, according * to the mode defined in &ieee80211_chanctx_switch_mode. + * This callback may sleep. * * @start_ap: Start operation on the AP interface, this is called after all the * information in bss_conf is set and beacon can be retrieved. A channel @@ -3266,6 +3291,10 @@ struct ieee80211_ops { unsigned int changed_flags, unsigned int *total_flags, u64 multicast); + void (*config_iface_filter)(struct ieee80211_hw *hw, + struct ieee80211_vif *vif, + unsigned int filter_flags, + unsigned int changed_flags); int (*set_tim)(struct ieee80211_hw *hw, struct ieee80211_sta *sta, bool set); int (*set_key)(struct ieee80211_hw *hw, enum set_key_cmd cmd, @@ -3349,7 +3378,7 @@ struct ieee80211_ops { struct ieee80211_vif *vif, enum ieee80211_ampdu_mlme_action action, struct ieee80211_sta *sta, u16 tid, u16 *ssn, - u8 buf_size); + u8 buf_size, bool amsdu); int (*get_survey)(struct ieee80211_hw *hw, int idx, struct survey_info *survey); void (*rfkill_poll)(struct ieee80211_hw *hw); |