| Age | Commit message (Collapse) | Author |
|---|
|
Write to the MMDC registers when resetting the MMDC after the
DDR I/Os have been floated.
This fixes the bug introduced by the commit:
"2a2f65bd07ad0f947794c2e5f2f825121805d663
MX6SL-Reset MMDC read FIFO in low power IDLE"
Signed-off-by: Ranjani Vaidyanathan <ra5478@freescale.com>
|
|
MMDC can clock in bad data due to the glitches caused by
changing the setting of various DDR IO pads in low power
IDLE to save power. Solution is to reset the MMDC read FIFO
before the DDR exits self-refresh.
Signed-off-by: Ranjani Vaidyanathan <ra5478@freescale.com>
|
|
Add the following power optimizations when all PLLs
are either disabled or in bypass:
1. Disable 2P5 in system IDLE mode and enable weak 2P5.
2. Set OSC bias current to -37.5% just before the WFI instruction
and set it back to 0% after WFI.
3. Enable the low power bandgap and power down the regular
bandgap.
Also lower AHB and AXI to 3MHz in this mode.
Signed-off-by: Ranjani Vaidyanathan <ra5478@freescale.com>
|
|
Ensure that the pull-up is enabled when the DQS line of LPDDR2
is floated when DDR freq is dropped to 24MHz. This is required
else its possible that the DDR will latch incorrect data when it
exits self-refresh.
CKE line should not be floated as it may cause DDR to incorrectly
exit self-refresh mode.
Also add 25 nops after the code that removes DDR from self-refresh.
We need this to ensure that the prefetcher block in A9 does not
access any instruction from DDR before the DDR exits self-refresh.
The A9 prefetch depth is about 23, hence 25 nops.
Signed-off-by: Ranjani Vaidyanathan <ra5478@freescale.com>
|
|
Set DDR to 50MHz in low power audio playback.
AHB/AXI are at 24MHz.
Also fix correct usecount for PLL1 main clock. If not
it causes issues when pll1_sw_clk's parent is changed.
Signed-off-by: Ranjani Vaidyanathan <ra5478@freescale.com>
|
|
When ARM enters WFI in low power IDLE state, float the DDR
IO pins to drop the power on the VDDHIGH rail.
Need to run WFI code from IRAM since DDR needs to be
put into self-refresh before changing the IO pins.
Drop AHB to 8MHz and DDR to 1MHz when ARM is in WFI when
in IDLE state.
Set IPG_PERCLK to run at 3MHz, since we want to maintain a
1:2.5 ratio between PERCLK to AHB_CLK.
Signed-off-by: Ranjani Vaidyanathan <ra5478@freescale.com>
|
