| Age | Commit message (Collapse) | Author |
|---|
|
The nanopi4 boards have the INTB pin of the RTL8211E phy wired up, so we
can make use of that and avoid having to poll for line status changes.
Apparently RTL8211E only requires 30ms of post-reset delay, so we may as
well save a little bit of time there as well.
Signed-off-by: Robin Murphy <robin.murphy@arm.com>
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
|
|
Describe the Bluetooth portion of the Ampak combo module - this is
either an AP6356S or an AP6212 depending on the board variant, but
there are no relevant compatibility differences between the two.
Signed-off-by: Robin Murphy <robin.murphy@arm.com>
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
|
|
The mmc.txt didn't explicitly say disable-wp is for SD card slot
only, but that is what it was designed for in the first place.
Remove all disable-wp from emmc or sdio controller.
Signed-off-by: Shawn Lin <shawn.lin@rock-chips.com>
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
|
|
For whatever reason, the sdmmc_dectn function isn't working properly
as-is, and microSD insertion and removal goes unnoticed. Using the pin
as a GPIO interrupt instead is rather noisy without any debouncing, but
is good enough to make it useful until someone feels inclined to figure
out how the vendor kernel/firmware gets the dedicated function to work
with no obvious difference in the pinmux/GRF configuration. Let's also
take the opportunity to tweak the node name so that all related pins
end up grouped together in the compiled DTB.
Signed-off-by: Robin Murphy <robin.murphy@arm.com>
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
|
|
The nanopi4 boards differ primarily in their power trees, with the main
5V and 3.3V rails having very different topologies on the smaller USB-C
powered boards vs. the 12V-powered T4, as well as minor variation in
other regulators related to various external connectors.
Additionally, the recovery key is only present on the T4 - ADC_IN1 is
simply pulled high and not exposed on the other boards - and the lowest
common denominator for MMC speed is actually HS200 according to the
vendor DTs.
Signed-off-by: Robin Murphy <robin.murphy@arm.com>
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
|
|
This adds a device tree for the NanoPC-T4 SBC, which is based on the
Rockchip RK3399 SoC and marketed by FriendlyELEC.
Known working:
- Serial
- Ethernet
- HDMI
- USB 2.0
All of the interesting stuff is in a .dtsi because there are at least
two other boards that share most of it: NanoPi M4 and NanoPi NEO4.
Signed-off-by: Tomeu Vizoso <tomeu.vizoso@collabora.com>
Reviewed-by: Rob Herring <robh@kernel.org>
[rm: various further cleanup]
Signed-off-by: Robin Murphy <robin.murphy@arm.com>
Signed-off-by: Heiko Stuebner <heiko@sntech.de>
|
