summaryrefslogtreecommitdiff
path: root/arch
AgeCommit message (Expand)Author
2013-01-28ENGR00241003-1 mx6: need to add delay in LDO voltage settingAnson Huang
2012-12-05ENGR00235624 Quad/DualLite ARD: MTD partition non alignedrel_imx_3.0.35_3.0.1rel_imx_3.0.35_3.0.0Alejandro Sierra
2012-11-30ENGR00235081 Quad DL: Fix chip select for SPI-NOR and flagsAlejandro Sierra
2012-11-30ENGR00234354-2: board-mx6q_sabreauto aline weim-nor partition layoutAdrian Alonso
2012-11-30ENGR00234354-1: board-mx6q_sabreauto aline spi-nor partition layoutAdrian Alonso
2012-11-17ENGR00233732 mx6dl: change 996M setpoint voltageAnson Huang
2012-11-07ENGR00231826 imx esdhc: Add the DMA mask for esdhc device register.Xinyu Chen
2012-11-07ENGR00232586 mx6: increase PUPSCR to make sure LDO is ready for resumeAnson Huang
2012-11-01ENGR00232087-1 MX6: Enable PU LDO gating.Hongzhang Yang
2012-10-31ENGR00231910 PU regulator: do not disable PU regulatorRobin Gong
2012-10-30ENGR00231063 Sabreauto: fix share pins SD Card and NFCAlejandro Sierra
2012-10-29ENGR00231321-1 mx6: remove wm8958 in imx6_defconfigGary Zhang
2012-10-26ENGR00230981-2 pfuze:standby voltage increase for PFMRobin Gong
2012-10-26ENGR00231331 mtd: gpmi: add kernel command line to enable gpmi in arm2 boardHuang Shijie
2012-10-26ENGR00231104 i.MX cpufreq: add scaling_available_freqs attributeLin Fuzhen
2012-10-25ENGR00230167 MX6 regulator: enable and raise the voltage of USB 3p0 LDOmake shi
2012-10-23ENGR00229785 pgc: disable display power gating when FB_MXC_ELCDIF_FB configuredRobby Cai
2012-10-23ENGR00227873-2 mx6sl: enable pxp v4l2 option in defconfigRobby Cai
2012-10-19ENGR00229905-2: board-mx6q_sabreauto add i2c ad7280 deviceAdrian Alonso
2012-10-18ENGR00230377 Sabreauto: Add eCompass supportAlejandro Sierra
2012-10-18ENGR00229725 Sabreauto: Support NAND SPINOR NOR SD on same configAlejandro Sierra
2012-10-17ENGR00229902: mx6q sabreauto tvin use io_init callback functionAdrian Alonso
2012-10-16ENGR00229924 MX6SL-Fix MMDC FIFO reset code.Ranjani Vaidyanathan
2012-10-16ENGR00229695 MX6x-Set RBC counters correctly in STOP mode.Ranjani Vaidyanathan
2012-10-15ENGR00229708 [MX6SL] Fix all build warnings.Nancy Chen
2012-10-15ENGR00229441 MX6SL-Reset MMDC read FIFO in low power IDLERanjani Vaidyanathan
2012-10-14ENGR00229470-1 MX6SL-Add support for debug UART to be sourced from 24MHz.Ranjani Vaidyanathan
2012-10-13ENGR00229464 MX6SL-Update the SOC voltages based on datasheetRanjani Vaidyanathan
2012-10-12ENGR00229437 [MX6SL] Fix AHB clock not changed to 3MHz in IDLE modeNancy Chen
2012-10-12ENGR00229299 [MX6SL] Kernel cannot boot if enable LOCKDEPNancy Chen
2012-10-09ENGR00227502-2 mx6sl: add csi v4l2 platform deviceRobby Cai
2012-10-09ENGR00227477 mx6qdl: system resume fail due to DDR not accessableAnson Huang
2012-10-09ENGR00227241 mx6sl: clk: sdhc can not work at lp idle modeRyan QIAN
2012-10-09ENGR00226392 MX6SL Bluetooth: Setup uart2 to enable bluetoothLionel Xu
2012-10-08ENGR00225700: ARM: mx6sl: Fix suspend/resume lockupRobert Lee
2012-10-08ENGR00227422: ARM: imx6sl: Adjust ARM and SOC stby voltagesRobert Lee
2012-10-08ENGR00227426 MX6SL-Fix bugs in low power IDLE modeRanjani Vaidyanathan
2012-10-09ENGR00227425 mx6sl: Need to save all registers before calling C functionAnson Huang
2012-10-09ENGR00227245 mx6q: Remove 400M setpoint for bus freqAnson Huang
2012-10-08ENGR00227249 MX6SL-Add support for low latency STANDBY mode.Ranjani Vaidyanathan
2012-10-08ENGR00227020: devices-common imx_dma_data duplicate struct definitionAdrian Alonso
2012-10-07ENGR00227250 MX6SL/MX6DL-Fix IRAM sizeRanjani Vaidyanathan
2012-09-29ENGR00225981-8 csi/imx6sl: add the platform-related settingRobby Cai
2012-09-29ENGR00225981-5 imx6sl: update the defconfigRobby Cai
2012-09-29ENGR00225960-04 mx6sl evk: Add sii902x GPIO/IOMux settingSandor Yu
2012-09-29ENGR00225960-01 Sii902x HDMI: added SII902x Config variableSandor Yu
2012-09-29ENGR00225735-1 PU anatop: PU regulator can be disabled/enabled by driversRobin Gong
2012-09-27ENGR00225894 MX6SL-Improve system IDLE power numbersRanjani Vaidyanathan
2012-09-27ENGR00226095-1 MX6 SL: add SPDIF support in EVKGary Zhang
2012-09-27ENGR00226096 mx6sl: remove high set point for usdhcRyan QIAN
generated by cgit v1.2.3 (git 2.0.4) at 2024-11-17 19:11:52 +0000