summaryrefslogtreecommitdiff
path: root/arch
AgeCommit message (Expand)Author
2009-10-13ENGR00115082 i.MX25 usb gadget driver registration failure.Jun Li
2009-10-13ENGR00115765-2 MX35: Change default command line in imx35_3stack_defconfigSammy
2009-10-13ENGR00115765-1 MX25: Change default command line in imx25_3stack_defconfigSammy
2009-10-13ENGR00112764 MX23: DCP crytpo test DCP-AES fail. 100%.Raj Rajasekaran
2009-10-13ENGR00115688 dvi: disable edid readAlan Tull
2009-10-13ENGR00115087 imx233: add battery driver to built-inZhou Jingyu
2009-10-13ENGR00103310 Initial imx_nfc NAND Flash MTD driverPatrick Turley
2009-10-13ENGR00115334: MX51: Donot scale arm_axi_clk in peripheral bus scaling.Ranjani Vaidyanathan-RA5478
2009-10-13ENGR00115321: MX51: Change STOP mode voltage based on DS0.3 datasheet.Ranjani Vaidyanathan-RA5478
2009-10-13ENGR00115081-1 iMX233 Merge UUT PatchFrank Li
2009-10-13ENGR00115013 MX51: System doesn't enter APM mode if DVFS CORE enabledNancy Chen
2009-10-13ENGR00114795 fix usb OTG co-work with remote wakeup issue.Jun Li
2009-10-13ENGR00114989 MX35 SPDIF driver failed to play 48KHz audioXinyu Chen
2009-10-13ENGR00114920 MX25: Pin mux warning when install camera modulesRichard Zhu
2009-10-13ENGR00114922 MX233 Bring DMA ZONE to kernelXinyu Chen
2009-10-13ENGR00114962 : change gpu UIO driver to moduleWu Guoxing
2009-10-13ENGR00114963 MX51: CPUFREQ is not trigged if DVFS CORE is enabledNancy Chen
2009-10-13ENGR00114957 MX25 FEC: GPIO port 1 (0-based), pin 3 warningWilliam Lai
2009-10-13ENGR00114881 MX51: Disable SAHARA by defaultKatherine Lu
2009-10-13ENGR00114937: MX51: Move USBOH3 and USB-PHY to source from PLL2 and 24MHz.Ranjani Vaidyanathan-RA5478
2009-10-13ENGR00114871 MX51: Add command line to enable peripheral SW Freq scalingNancy Chen
2009-10-13ENGR00114905 MX25: Fix touch screen failure caseNiu
2009-10-13ENGR000114910 Change some EMI setting for DDR 133MHz to make system stableRobby Cai
2009-10-13ENGR00114851 MX51: Fix SSI1 SDMA data transfer failureWallace Wang
2009-10-13ENGR00114867 MX51: tristate i2c levelshifterAlan Tull
2009-10-13ENGR00114644-2 MX51 PWM: Correction for the PWMWilliam Lai
2009-10-13ENGR00114644-1 MX51 PWM: Add pwm and backlight devicesWilliam Lai
2009-10-13ENGR00113292 MX25: Set GPT clock's parent to ahb_clkXiexiaobo
2009-10-13ENGR00114787 MX31: Unable to write to PWM registersWilliam Lai
2009-10-13ENGR00114536 [MX233_BSP] USB_HOST unable to enumerate USB deviceFrank Li
2009-10-13ENGR00114738 MX51 BBG: Add OneWire supportLily Zhang
2009-10-13ENGR00114737 iMX233 get mac address from fuse at EVK boardFrank Li
2009-10-13ENGR00114655 mitsubishi lvds xga lcd support for babbage 2.5b00984
2009-10-13ENGR00113597 imx233 add irq disable routineZhou Jingyu
2009-10-13ENGR00114736 Fix build break by adding mxc_dvfs.hNancy Chen
2009-10-13ENGR00114686-1 MX51: Enable other CPUFREQ governorsNancy Chen
2009-10-13ENGR00114686 DVFS-CORE: Use GPC STRT bit to control DVFSNancy Chen
2009-10-13ENGR00114689 CPUFREQ: Add conservative governor supportNancy Chen
2009-10-13ENGR00114685 MX51: Change the GP voltages for 167MHz and 800MHzNancy Chen
2009-10-13ENGR00114599 mx51: Add gpu2d uio driverRob Herring
2009-10-13ENGR00114325-2 MX25:Support SIM card driverRichard Zhu
2009-10-13ENGR00112310 MX25: Fix the USB gadget transfer halt issueXiexiaobo
2009-10-13ENGR00114667 MX25: Fix the code to set bit value incorrectly in clock.cXiexiaobo
2009-10-13ENGR00114692 GPU: use axi_a_clk for both 2d and 3dWu Guoxing
2009-10-13imx: re-work of PWM, add i.MX21 supportHolger Schurig
2009-10-13MXC: add pwm driver for i.MX SoCsSascha Hauer
2009-10-13ENGR00114646 MX35: Add osc_audio clock Enable/Disable functionWallace Wang
2009-10-13ENGR00114625 BABBAGE: Add spdif supportWallace Wang
2009-10-13ENGR00114665 iMX233-EVK work around EVK-board can't recongize some SD CardFrank Li
2009-10-13ENGR00114617 Support OV3640 camera on BBG2.5 accessory boardLiu Ying
generated by cgit v1.2.3 (git 2.0.4) at 2024-12-28 20:01:10 +0000