From c04ae531eea6c2a983d2e32f965383a5dde92e9f Mon Sep 17 00:00:00 2001 From: Marek Vasut Date: Wed, 2 Aug 2023 16:47:25 +0200 Subject: media: ov5640: Enable MIPI interface in ov5640_set_power_mipi() [ Upstream commit 98cb72d3b9c5e03b10fa993752ecfcbd9c572d8c ] Set OV5640_REG_IO_MIPI_CTRL00 bit 2 to 1 instead of 0, since 1 means MIPI CSI2 interface, while 0 means CPI parallel interface. In the ov5640_set_power_mipi() the interface should obviously be set to MIPI CSI2 since this functions is used to power up the sensor when operated in MIPI CSI2 mode. The sensor should not be in CPI mode in that case. This fixes a corner case where capturing the first frame on i.MX8MN with CSI/ISI resulted in corrupted frame. Fixes: aa4bb8b8838f ("media: ov5640: Re-work MIPI startup sequence") Reviewed-by: Jacopo Mondi Tested-by: Jacopo Mondi # [Test on imx6q] Signed-off-by: Marek Vasut Tested-by: Jai Luthra # [Test on bplay, sk-am62] Signed-off-by: Sakari Ailus Signed-off-by: Mauro Carvalho Chehab Signed-off-by: Sasha Levin --- drivers/media/i2c/ov5640.c | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/drivers/media/i2c/ov5640.c b/drivers/media/i2c/ov5640.c index 76a9fa6d6d5c..2e5a49e87a74 100644 --- a/drivers/media/i2c/ov5640.c +++ b/drivers/media/i2c/ov5640.c @@ -1927,9 +1927,9 @@ static int ov5640_set_power_mipi(struct ov5640_dev *sensor, bool on) * "ov5640_set_stream_mipi()") * [4] = 0 : Power up MIPI HS Tx * [3] = 0 : Power up MIPI LS Rx - * [2] = 0 : MIPI interface disabled + * [2] = 1 : MIPI interface enabled */ - ret = ov5640_write_reg(sensor, OV5640_REG_IO_MIPI_CTRL00, 0x40); + ret = ov5640_write_reg(sensor, OV5640_REG_IO_MIPI_CTRL00, 0x44); if (ret) return ret; -- cgit v1.2.3