From ff803ed4ddbbf9f4bbd439b5e23dc25a4e0cce7a Mon Sep 17 00:00:00 2001 From: Courtney Cavin Date: Sun, 11 Dec 2011 23:38:27 -0800 Subject: Input: add driver for Sharp gp2ap002a00f proximity sensor This driver adds support for Sharp's GP2AP002A00F proximity sensor. The proximity is measured as a binary switch, i.e. an object is either detected or not detected. Hence, this driver is implemented as a switch that reports SW_FRONT_PROXIMITY. Reviewed-by: Datta Shubhrajyoti Signed-off-by: Courtney Cavin Signed-off-by: Oskar Andero Signed-off-by: Dmitry Torokhov --- drivers/input/misc/Kconfig | 11 +++++++++++ 1 file changed, 11 insertions(+) (limited to 'drivers/input/misc/Kconfig') diff --git a/drivers/input/misc/Kconfig b/drivers/input/misc/Kconfig index e53b443d1e33..7b46781c30c9 100644 --- a/drivers/input/misc/Kconfig +++ b/drivers/input/misc/Kconfig @@ -179,6 +179,17 @@ config INPUT_APANEL To compile this driver as a module, choose M here: the module will be called apanel. +config INPUT_GP2A + tristate "Sharp GP2AP002A00F I2C Proximity/Opto sensor driver" + depends on I2C + depends on GENERIC_GPIO + help + Say Y here if you have a Sharp GP2AP002A00F proximity/als combo-chip + hooked to an I2C bus. + + To compile this driver as a module, choose M here: the + module will be called gp2ap002a00f. + config INPUT_GPIO_TILT_POLLED tristate "Polled GPIO tilt switch" depends on GENERIC_GPIO -- cgit v1.2.3