From 646cdb32831eebe8c2f742c293d0d266326854d9 Mon Sep 17 00:00:00 2001 From: Alexander Beregalov Date: Tue, 26 May 2009 12:35:25 +0000 Subject: 3c50x: convert printk() to pr_() Signed-off-by: Alexander Beregalov Signed-off-by: David S. Miller --- drivers/net/3c503.c | 36 +++++++++++++++++++----------------- 1 file changed, 19 insertions(+), 17 deletions(-) (limited to 'drivers/net/3c503.c') diff --git a/drivers/net/3c503.c b/drivers/net/3c503.c index 4f08bd995836..134638a9759f 100644 --- a/drivers/net/3c503.c +++ b/drivers/net/3c503.c @@ -234,16 +234,16 @@ el2_probe1(struct net_device *dev, int ioaddr) } if (ei_debug && version_printed++ == 0) - printk(version); + pr_debug("%s", version); dev->base_addr = ioaddr; - printk("%s: 3c503 at i/o base %#3x, node ", dev->name, ioaddr); + pr_info("%s: 3c503 at i/o base %#3x, node ", dev->name, ioaddr); /* Retrieve and print the ethernet address. */ for (i = 0; i < 6; i++) dev->dev_addr[i] = inb(ioaddr + i); - printk("%pM", dev->dev_addr); + pr_cont("%pM", dev->dev_addr); /* Map the 8390 back into the window. */ outb(ECNTRL_THIN, ioaddr + 0x406); @@ -256,7 +256,8 @@ el2_probe1(struct net_device *dev, int ioaddr) outb_p(E8390_PAGE0, ioaddr + E8390_CMD); /* Probe for, turn on and clear the board's shared memory. */ - if (ei_debug > 2) printk(" memory jumpers %2.2x ", membase_reg); + if (ei_debug > 2) + pr_cont(" memory jumpers %2.2x ", membase_reg); outb(EGACFR_NORM, ioaddr + 0x405); /* Enable RAM */ /* This should be probed for (or set via an ioctl()) at run-time. @@ -268,7 +269,7 @@ el2_probe1(struct net_device *dev, int ioaddr) #else ei_status.interface_num = dev->mem_end & 0xf; #endif - printk(", using %sternal xcvr.\n", ei_status.interface_num == 0 ? "in" : "ex"); + pr_cont(", using %sternal xcvr.\n", ei_status.interface_num == 0 ? "in" : "ex"); if ((membase_reg & 0xf0) == 0) { dev->mem_start = 0; @@ -292,7 +293,7 @@ el2_probe1(struct net_device *dev, int ioaddr) writel(test_val, mem_base + i); if (readl(mem_base) != 0xba5eba5e || readl(mem_base + i) != test_val) { - printk("3c503: memory failure or memory address conflict.\n"); + pr_warning("3c503: memory failure or memory address conflict.\n"); dev->mem_start = 0; ei_status.name = "3c503-PIO"; iounmap(mem_base); @@ -344,7 +345,7 @@ el2_probe1(struct net_device *dev, int ioaddr) if (dev->irq == 2) dev->irq = 9; else if (dev->irq > 5 && dev->irq != 9) { - printk("3c503: configured interrupt %d invalid, will use autoIRQ.\n", + pr_warning("3c503: configured interrupt %d invalid, will use autoIRQ.\n", dev->irq); dev->irq = 0; } @@ -359,7 +360,7 @@ el2_probe1(struct net_device *dev, int ioaddr) goto out1; if (dev->mem_start) - printk("%s: %s - %dkB RAM, 8kB shared mem window at %#6lx-%#6lx.\n", + pr_info("%s: %s - %dkB RAM, 8kB shared mem window at %#6lx-%#6lx.\n", dev->name, ei_status.name, (wordlength+1)<<3, dev->mem_start, dev->mem_end-1); @@ -367,7 +368,7 @@ el2_probe1(struct net_device *dev, int ioaddr) { ei_status.tx_start_page = EL2_MB1_START_PG; ei_status.rx_start_page = EL2_MB1_START_PG + TX_PAGES; - printk("\n%s: %s, %dkB RAM, using programmed I/O (REJUMPER for SHARED MEMORY).\n", + pr_info("%s: %s, %dkB RAM, using programmed I/O (REJUMPER for SHARED MEMORY).\n", dev->name, ei_status.name, (wordlength+1)<<3); } release_region(ioaddr + 0x400, 8); @@ -435,15 +436,16 @@ static void el2_reset_8390(struct net_device *dev) { if (ei_debug > 1) { - printk("%s: Resetting the 3c503 board...", dev->name); - printk("%#lx=%#02x %#lx=%#02x %#lx=%#02x...", E33G_IDCFR, inb(E33G_IDCFR), + pr_debug("%s: Resetting the 3c503 board...", dev->name); + pr_cont(" %#lx=%#02x %#lx=%#02x %#lx=%#02x...", E33G_IDCFR, inb(E33G_IDCFR), E33G_CNTRL, inb(E33G_CNTRL), E33G_GACFR, inb(E33G_GACFR)); } outb_p(ECNTRL_RESET|ECNTRL_THIN, E33G_CNTRL); ei_status.txing = 0; outb_p(ei_status.interface_num==0 ? ECNTRL_THIN : ECNTRL_AUI, E33G_CNTRL); el2_init_card(dev); - if (ei_debug > 1) printk("done\n"); + if (ei_debug > 1) + pr_cont("done\n"); } /* Initialize the 3c503 GA registers after a reset. */ @@ -529,7 +531,7 @@ el2_block_output(struct net_device *dev, int count, { if(!boguscount--) { - printk("%s: FIFO blocked in el2_block_output.\n", dev->name); + pr_notice("%s: FIFO blocked in el2_block_output.\n", dev->name); el2_reset_8390(dev); goto blocked; } @@ -581,7 +583,7 @@ el2_get_8390_hdr(struct net_device *dev, struct e8390_pkt_hdr *hdr, int ring_pag { if(!boguscount--) { - printk("%s: FIFO blocked in el2_get_8390_hdr.\n", dev->name); + pr_notice("%s: FIFO blocked in el2_get_8390_hdr.\n", dev->name); memset(hdr, 0x00, sizeof(struct e8390_pkt_hdr)); el2_reset_8390(dev); goto blocked; @@ -645,7 +647,7 @@ el2_block_input(struct net_device *dev, int count, struct sk_buff *skb, int ring { if(!boguscount--) { - printk("%s: FIFO blocked in el2_block_input.\n", dev->name); + pr_notice("%s: FIFO blocked in el2_block_input.\n", dev->name); el2_reset_8390(dev); goto blocked; } @@ -707,7 +709,7 @@ init_module(void) for (this_dev = 0; this_dev < MAX_EL2_CARDS; this_dev++) { if (io[this_dev] == 0) { if (this_dev != 0) break; /* only autoprobe 1st one */ - printk(KERN_NOTICE "3c503.c: Presently autoprobing (not recommended) for a single card.\n"); + pr_notice("3c503.c: Presently autoprobing (not recommended) for a single card.\n"); } dev = alloc_eip_netdev(); if (!dev) @@ -720,7 +722,7 @@ init_module(void) continue; } free_netdev(dev); - printk(KERN_WARNING "3c503.c: No 3c503 card found (i/o = 0x%x).\n", io[this_dev]); + pr_warning("3c503.c: No 3c503 card found (i/o = 0x%x).\n", io[this_dev]); break; } if (found) -- cgit v1.2.3