From 559a208028387ffb230f502f8137c278b311803b Mon Sep 17 00:00:00 2001 From: Aaron Sierra Date: Tue, 29 Nov 2016 10:03:56 -0600 Subject: igb: reset the PHY before reading the PHY ID [ Upstream commit 182785335447957409282ca745aa5bc3968facee ] Several people have reported firmware leaving the I210/I211 PHY's page select register set to something other than the default of zero. This causes the first accesses, PHY_IDx register reads, to access something else, resulting in device probe failure: igb: Intel(R) Gigabit Ethernet Network Driver - version 5.4.0-k igb: Copyright (c) 2007-2014 Intel Corporation. igb: probe of 0000:01:00.0 failed with error -2 This problem began for them after a previous patch I submitted was applied: commit 2a3cdead8b408351fa1e3079b220fa331480ffbc Author: Aaron Sierra Date: Tue Nov 3 12:37:09 2015 -0600 igb: Remove GS40G specific defines/functions I personally experienced this problem after attempting to PXE boot from I210 devices using this firmware: Intel(R) Boot Agent GE v1.5.78 Copyright (C) 1997-2014, Intel Corporation Resetting the PHY before reading from it, ensures the page select register is in its default state and doesn't make assumptions about the PHY's register set before the PHY has been probed. Cc: Matwey V. Kornilov Cc: Chris Arges Cc: Jochen Henneberg Signed-off-by: Aaron Sierra Tested-by: Matwey V. Kornilov Tested-by: Chris J Arges Tested-by: Aaron Brown Signed-off-by: Jeff Kirsher Signed-off-by: Sasha Levin Signed-off-by: Greg Kroah-Hartman --- drivers/net/ethernet/intel/igb/e1000_82575.c | 11 +++++++++++ 1 file changed, 11 insertions(+) (limited to 'drivers/net') diff --git a/drivers/net/ethernet/intel/igb/e1000_82575.c b/drivers/net/ethernet/intel/igb/e1000_82575.c index 97bf0c3d5c69..f3f3b95d5512 100644 --- a/drivers/net/ethernet/intel/igb/e1000_82575.c +++ b/drivers/net/ethernet/intel/igb/e1000_82575.c @@ -223,6 +223,17 @@ static s32 igb_init_phy_params_82575(struct e1000_hw *hw) hw->bus.func = (rd32(E1000_STATUS) & E1000_STATUS_FUNC_MASK) >> E1000_STATUS_FUNC_SHIFT; + /* Make sure the PHY is in a good state. Several people have reported + * firmware leaving the PHY's page select register set to something + * other than the default of zero, which causes the PHY ID read to + * access something other than the intended register. + */ + ret_val = hw->phy.ops.reset(hw); + if (ret_val) { + hw_dbg("Error resetting the PHY.\n"); + goto out; + } + /* Set phy->phy_addr and phy->id. */ ret_val = igb_get_phy_id_82575(hw); if (ret_val) -- cgit v1.2.3