From 2479c7300ed943d62c88cd928ddccb4677c71ad4 Mon Sep 17 00:00:00 2001 From: Mika Westerberg Date: Thu, 29 Jan 2015 12:44:48 +0200 Subject: pinctrl: cherryview: Configure HiZ pins to be input when requested as GPIOs If the pin is in HiZ mode when it is requested as GPIO its value cannot be read (it always returns 0). In order to cope with the Linux GPIO subsystem where we do not have such state at all, turn the pin to be input instead. Reported-by: Jerome Blin Signed-off-by: Mika Westerberg Signed-off-by: Linus Walleij --- drivers/pinctrl/intel/pinctrl-cherryview.c | 17 +++++++++++++++-- 1 file changed, 15 insertions(+), 2 deletions(-) (limited to 'drivers/pinctrl/intel') diff --git a/drivers/pinctrl/intel/pinctrl-cherryview.c b/drivers/pinctrl/intel/pinctrl-cherryview.c index a2f23c357df3..3034fd03bced 100644 --- a/drivers/pinctrl/intel/pinctrl-cherryview.c +++ b/drivers/pinctrl/intel/pinctrl-cherryview.c @@ -880,9 +880,22 @@ static int chv_gpio_request_enable(struct pinctrl_dev *pctldev, value &= ~CHV_PADCTRL1_INVRXTX_MASK; chv_writel(value, reg); - /* Switch to a GPIO mode */ reg = chv_padreg(pctrl, offset, CHV_PADCTRL0); - value = readl(reg) | CHV_PADCTRL0_GPIOEN; + value = readl(reg); + + /* + * If the pin is in HiZ mode (both TX and RX buffers are + * disabled) we turn it to be input now. + */ + if ((value & CHV_PADCTRL0_GPIOCFG_MASK) == + (CHV_PADCTRL0_GPIOCFG_HIZ << CHV_PADCTRL0_GPIOCFG_SHIFT)) { + value &= ~CHV_PADCTRL0_GPIOCFG_MASK; + value |= CHV_PADCTRL0_GPIOCFG_GPI << + CHV_PADCTRL0_GPIOCFG_SHIFT; + } + + /* Switch to a GPIO mode */ + value |= CHV_PADCTRL0_GPIOEN; chv_writel(value, reg); } -- cgit v1.2.3