From bec658ff31453a5726b1c188674d587a5d40c482 Mon Sep 17 00:00:00 2001 From: Steve Wise Date: Sat, 18 Sep 2010 19:38:21 -0500 Subject: RDMA/cxgb3: Turn off RX coalescing for iWARP connections The HW by default has RX coalescing on. For iWARP connections, this causes a 100ms delay in connection establishement due to the ingress MPA Start message being stalled in HW. So explicitly turn RX coalescing off when setting up iWARP connections. This was causing very bad performance for NP64 gather operations using Open MPI, due to the way it sets up connections on larger jobs. Signed-off-by: Steve Wise Cc: Signed-off-by: Roland Dreier --- drivers/infiniband/hw/cxgb3/iwch_cm.c | 6 ++++-- 1 file changed, 4 insertions(+), 2 deletions(-) (limited to 'drivers') diff --git a/drivers/infiniband/hw/cxgb3/iwch_cm.c b/drivers/infiniband/hw/cxgb3/iwch_cm.c index d88077a21994..13c88871dc3b 100644 --- a/drivers/infiniband/hw/cxgb3/iwch_cm.c +++ b/drivers/infiniband/hw/cxgb3/iwch_cm.c @@ -463,7 +463,8 @@ static int send_connect(struct iwch_ep *ep) V_MSS_IDX(mtu_idx) | V_L2T_IDX(ep->l2t->idx) | V_TX_CHANNEL(ep->l2t->smt_idx); opt0l = V_TOS((ep->tos >> 2) & M_TOS) | V_RCV_BUFSIZ(rcv_win>>10); - opt2 = V_FLAVORS_VALID(1) | V_CONG_CONTROL_FLAVOR(cong_flavor); + opt2 = F_RX_COALESCE_VALID | V_RX_COALESCE(0) | V_FLAVORS_VALID(1) | + V_CONG_CONTROL_FLAVOR(cong_flavor); skb->priority = CPL_PRIORITY_SETUP; set_arp_failure_handler(skb, act_open_req_arp_failure); @@ -1280,7 +1281,8 @@ static void accept_cr(struct iwch_ep *ep, __be32 peer_ip, struct sk_buff *skb) V_MSS_IDX(mtu_idx) | V_L2T_IDX(ep->l2t->idx) | V_TX_CHANNEL(ep->l2t->smt_idx); opt0l = V_TOS((ep->tos >> 2) & M_TOS) | V_RCV_BUFSIZ(rcv_win>>10); - opt2 = V_FLAVORS_VALID(1) | V_CONG_CONTROL_FLAVOR(cong_flavor); + opt2 = F_RX_COALESCE_VALID | V_RX_COALESCE(0) | V_FLAVORS_VALID(1) | + V_CONG_CONTROL_FLAVOR(cong_flavor); rpl = cplhdr(skb); rpl->wr.wr_hi = htonl(V_WR_OP(FW_WROPCODE_FORWARD)); -- cgit v1.2.3