From d2c6d518c21d73d96616e08a19eccd4642f4bafa Mon Sep 17 00:00:00 2001 From: Balamanikandan Gunasundar Date: Fri, 25 Aug 2023 15:21:56 +0530 Subject: mmc: atmel-mci: move atmel MCI header file Move the contents of linux/atmel-mci.h into drivers/mmc/host/atmel-mci.c as it is only used in one file Signed-off-by: Balamanikandan Gunasundar Reviewed-by: Ludovic Desroches Link: https://lore.kernel.org/r/20230825095157.76073-3-balamanikandan.gunasundar@microchip.com Signed-off-by: Ulf Hansson --- include/linux/atmel-mci.h | 46 ---------------------------------------------- 1 file changed, 46 deletions(-) delete mode 100644 include/linux/atmel-mci.h (limited to 'include/linux') diff --git a/include/linux/atmel-mci.h b/include/linux/atmel-mci.h deleted file mode 100644 index 017e7d8f6126..000000000000 --- a/include/linux/atmel-mci.h +++ /dev/null @@ -1,46 +0,0 @@ -/* SPDX-License-Identifier: GPL-2.0 */ -#ifndef __LINUX_ATMEL_MCI_H -#define __LINUX_ATMEL_MCI_H - -#include -#include - -#define ATMCI_MAX_NR_SLOTS 2 - -/** - * struct mci_slot_pdata - board-specific per-slot configuration - * @bus_width: Number of data lines wired up the slot - * @detect_pin: GPIO pin wired to the card detect switch - * @wp_pin: GPIO pin wired to the write protect sensor - * @detect_is_active_high: The state of the detect pin when it is active - * @non_removable: The slot is not removable, only detect once - * - * If a given slot is not present on the board, @bus_width should be - * set to 0. The other fields are ignored in this case. - * - * Any pins that aren't available should be set to a negative value. - * - * Note that support for multiple slots is experimental -- some cards - * might get upset if we don't get the clock management exactly right. - * But in most cases, it should work just fine. - */ -struct mci_slot_pdata { - unsigned int bus_width; - struct gpio_desc *detect_pin; - struct gpio_desc *wp_pin; - bool detect_is_active_high; - bool non_removable; -}; - -/** - * struct mci_platform_data - board-specific MMC/SDcard configuration - * @dma_slave: DMA slave interface to use in data transfers. - * @slot: Per-slot configuration data. - */ -struct mci_platform_data { - void *dma_slave; - dma_filter_fn dma_filter; - struct mci_slot_pdata slot[ATMCI_MAX_NR_SLOTS]; -}; - -#endif /* __LINUX_ATMEL_MCI_H */ -- cgit v1.2.3