blob: e13787498bcf443977ca534ebb2ccfe66fc87cb3 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
|
* Marvell PXA GPIO controller
Required properties:
- compatible : Should be "mrvl,pxa-gpio" or "mrvl,mmp-gpio"
- reg : Address and length of the register set for the device
- interrupts : Should be the port interrupt shared by all gpio pins.
There're three gpio interrupts in arch-pxa, and they're gpio0,
gpio1 and gpio_mux. There're only one gpio interrupt in arch-mmp,
gpio_mux.
- interrupt-name : Should be the name of irq resource. Each interrupt
binds its interrupt-name.
- interrupt-controller : Identifies the node as an interrupt controller.
- #interrupt-cells: Specifies the number of cells needed to encode an
interrupt source.
- gpio-controller : Marks the device node as a gpio controller.
- #gpio-cells : Should be one. It is the pin number.
Example:
gpio: gpio@d4019000 {
compatible = "mrvl,mmp-gpio";
reg = <0xd4019000 0x1000>;
interrupts = <49>;
interrupt-name = "gpio_mux";
gpio-controller;
#gpio-cells = <1>;
interrupt-controller;
#interrupt-cells = <1>;
};
* Marvell Orion GPIO Controller
Required properties:
- compatible : Should be "marvell,orion-gpio"
- reg : Address and length of the register set for controller.
- gpio-controller : So we know this is a gpio controller.
- ngpio : How many gpios this controller has.
- interrupts : Up to 4 Interrupts for the controller.
Optional properties:
- mask-offset : For SMP Orions, offset for Nth CPU
Example:
gpio0: gpio@10100 {
compatible = "marvell,orion-gpio";
#gpio-cells = <2>;
gpio-controller;
reg = <0x10100 0x40>;
ngpio = <32>;
interrupts = <35>, <36>, <37>, <38>;
};
|
