blob: cae5f259abd8c80b5612e169dd12e2717d820e33 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
|
Freescale's NAND flash controller (NFC)
This variant of the Freescale NAND flash controller (NFC) can be found on
Vybrid (vf610), MPC5125, MCF54418 and Kinetis K70.
Required properties:
- compatible: Should be set to "fsl,vf610-nfc"
- reg: address range of the NFC
- interrupts: interrupt of the NFC
- nand-bus-width: see nand.txt
- nand-ecc-mode: see nand.txt
- nand-on-flash-bbt: see nand.txt
- assigned-clocks: main clock from the SoC, for Vybrid <&clks VF610_CLK_NFC>;
- assigned-clock-rates: The NAND bus timing is derived from this clock
rate and should not exceed maximum timing for any NAND memory chip
in a board stuffing. Typical NAND memory timings derived from this
clock are found in the SoC hardware reference manual. Furthermore,
there might be restrictions on maximum rates when using hardware ECC.
- #address-cells, #size-cells : Must be present if the device has sub-nodes
representing partitions.
Required properties for hardware ECC:
- nand-ecc-strength: supported strengths are 24 and 32 bit (see nand.txt)
- nand-ecc-step-size: step size equals page size, currently only 2k pages are
supported
Example:
nfc: nand@400e0000 {
compatible = "fsl,vf610-nfc";
#address-cells = <1>;
#size-cells = <1>;
reg = <0x400e0000 0x4000>;
interrupts = <GIC_SPI 83 IRQ_TYPE_LEVEL_HIGH>;
clocks = <&clks VF610_CLK_NFC>;
clock-names = "nfc";
assigned-clocks = <&clks VF610_CLK_NFC>;
assigned-clock-rates = <33000000>;
nand-bus-width = <8>;
nand-ecc-mode = "hw";
nand-ecc-strength = <32>;
nand-ecc-step-size = <2048>;
nand-on-flash-bbt;
};
|
