diff options
Diffstat (limited to 'drivers/spi/designware_spi.c')
| -rw-r--r-- | drivers/spi/designware_spi.c | 40 |
1 files changed, 15 insertions, 25 deletions
diff --git a/drivers/spi/designware_spi.c b/drivers/spi/designware_spi.c index 06f777461ec..0e93b62eee1 100644 --- a/drivers/spi/designware_spi.c +++ b/drivers/spi/designware_spi.c @@ -114,26 +114,16 @@ struct dw_spi_priv { void *rx_end; }; -static inline u32 dw_readl(struct dw_spi_priv *priv, u32 offset) +static inline u32 dw_read(struct dw_spi_priv *priv, u32 offset) { return __raw_readl(priv->regs + offset); } -static inline void dw_writel(struct dw_spi_priv *priv, u32 offset, u32 val) +static inline void dw_write(struct dw_spi_priv *priv, u32 offset, u32 val) { __raw_writel(val, priv->regs + offset); } -static inline u16 dw_readw(struct dw_spi_priv *priv, u32 offset) -{ - return __raw_readw(priv->regs + offset); -} - -static inline void dw_writew(struct dw_spi_priv *priv, u32 offset, u16 val) -{ - __raw_writew(val, priv->regs + offset); -} - static int request_gpio_cs(struct udevice *bus) { #if defined(CONFIG_DM_GPIO) && !defined(CONFIG_SPL_BUILD) @@ -179,14 +169,14 @@ static int dw_spi_ofdata_to_platdata(struct udevice *bus) static inline void spi_enable_chip(struct dw_spi_priv *priv, int enable) { - dw_writel(priv, DW_SPI_SSIENR, (enable ? 1 : 0)); + dw_write(priv, DW_SPI_SSIENR, (enable ? 1 : 0)); } /* Restart the controller, disable all interrupts, clean rx fifo */ static void spi_hw_init(struct dw_spi_priv *priv) { spi_enable_chip(priv, 0); - dw_writel(priv, DW_SPI_IMR, 0xff); + dw_write(priv, DW_SPI_IMR, 0xff); spi_enable_chip(priv, 1); /* @@ -197,13 +187,13 @@ static void spi_hw_init(struct dw_spi_priv *priv) u32 fifo; for (fifo = 1; fifo < 256; fifo++) { - dw_writew(priv, DW_SPI_TXFLTR, fifo); - if (fifo != dw_readw(priv, DW_SPI_TXFLTR)) + dw_write(priv, DW_SPI_TXFLTR, fifo); + if (fifo != dw_read(priv, DW_SPI_TXFLTR)) break; } priv->fifo_len = (fifo == 1) ? 0 : fifo; - dw_writew(priv, DW_SPI_TXFLTR, 0); + dw_write(priv, DW_SPI_TXFLTR, 0); } debug("%s: fifo_len=%d\n", __func__, priv->fifo_len); } @@ -272,7 +262,7 @@ static inline u32 tx_max(struct dw_spi_priv *priv) u32 tx_left, tx_room, rxtx_gap; tx_left = (priv->tx_end - priv->tx) / (priv->bits_per_word >> 3); - tx_room = priv->fifo_len - dw_readw(priv, DW_SPI_TXFLR); + tx_room = priv->fifo_len - dw_read(priv, DW_SPI_TXFLR); /* * Another concern is about the tx/rx mismatch, we @@ -293,7 +283,7 @@ static inline u32 rx_max(struct dw_spi_priv *priv) { u32 rx_left = (priv->rx_end - priv->rx) / (priv->bits_per_word >> 3); - return min_t(u32, rx_left, dw_readw(priv, DW_SPI_RXFLR)); + return min_t(u32, rx_left, dw_read(priv, DW_SPI_RXFLR)); } static void dw_writer(struct dw_spi_priv *priv) @@ -309,7 +299,7 @@ static void dw_writer(struct dw_spi_priv *priv) else txw = *(u16 *)(priv->tx); } - dw_writew(priv, DW_SPI_DR, txw); + dw_write(priv, DW_SPI_DR, txw); debug("%s: tx=0x%02x\n", __func__, txw); priv->tx += priv->bits_per_word >> 3; } @@ -321,7 +311,7 @@ static void dw_reader(struct dw_spi_priv *priv) u16 rxw; while (max--) { - rxw = dw_readw(priv, DW_SPI_DR); + rxw = dw_read(priv, DW_SPI_DR); debug("%s: rx=0x%02x\n", __func__, rxw); /* Care about rx if the transfer's original "rx" is not null */ @@ -410,8 +400,8 @@ static int dw_spi_xfer(struct udevice *dev, unsigned int bitlen, debug("%s: cr0=%08x\n", __func__, cr0); /* Reprogram cr0 only if changed */ - if (dw_readw(priv, DW_SPI_CTRL0) != cr0) - dw_writew(priv, DW_SPI_CTRL0, cr0); + if (dw_read(priv, DW_SPI_CTRL0) != cr0) + dw_write(priv, DW_SPI_CTRL0, cr0); /* * Configure the desired SS (slave select 0...3) in the controller @@ -419,7 +409,7 @@ static int dw_spi_xfer(struct udevice *dev, unsigned int bitlen, * automatically. So no cs_activate() etc is needed in this driver. */ cs = spi_chip_select(dev); - dw_writel(priv, DW_SPI_SER, 1 << cs); + dw_write(priv, DW_SPI_SER, 1 << cs); /* Enable controller after writing control registers */ spi_enable_chip(priv, 1); @@ -462,7 +452,7 @@ static int dw_spi_set_speed(struct udevice *bus, uint speed) /* clk_div doesn't support odd number */ clk_div = priv->bus_clk_rate / speed; clk_div = (clk_div + 1) & 0xfffe; - dw_writel(priv, DW_SPI_BAUDR, clk_div); + dw_write(priv, DW_SPI_BAUDR, clk_div); /* Enable controller after writing control registers */ spi_enable_chip(priv, 1); |