diff options
Diffstat (limited to 'include/configs/bf533-stamp.h')
| -rw-r--r-- | include/configs/bf533-stamp.h | 96 |
1 files changed, 48 insertions, 48 deletions
diff --git a/include/configs/bf533-stamp.h b/include/configs/bf533-stamp.h index 6e138b86200..5ad99a2fd49 100644 --- a/include/configs/bf533-stamp.h +++ b/include/configs/bf533-stamp.h @@ -93,13 +93,13 @@ * Flash settings */ -#define CFG_FLASH_CFI /* The flash is CFI compatible */ +#define CONFIG_SYS_FLASH_CFI /* The flash is CFI compatible */ #define CONFIG_FLASH_CFI_DRIVER /* Use common CFI driver */ -#define CFG_FLASH_CFI_AMD_RESET +#define CONFIG_SYS_FLASH_CFI_AMD_RESET -#define CFG_FLASH_BASE 0x20000000 -#define CFG_MAX_FLASH_BANKS 1 /* max number of memory banks */ -#define CFG_MAX_FLASH_SECT 67 /* max number of sectors on one chip */ +#define CONFIG_SYS_FLASH_BASE 0x20000000 +#define CONFIG_SYS_MAX_FLASH_BANKS 1 /* max number of memory banks */ +#define CONFIG_SYS_MAX_FLASH_SECT 67 /* max number of sectors on one chip */ #if (CONFIG_BFIN_BOOT_MODE == BFIN_BOOT_SPI_MASTER) #define CONFIG_ENV_IS_IN_EEPROM 1 @@ -108,29 +108,29 @@ #else #define CONFIG_ENV_IS_IN_FLASH 1 #define CONFIG_ENV_ADDR 0x20004000 -#define CONFIG_ENV_OFFSET (CONFIG_ENV_ADDR - CFG_FLASH_BASE) +#define CONFIG_ENV_OFFSET (CONFIG_ENV_ADDR - CONFIG_SYS_FLASH_BASE) #endif #define CONFIG_ENV_SIZE 0x2000 #define CONFIG_ENV_SECT_SIZE 0x2000 /* Total Size of Environment Sector */ #define ENV_IS_EMBEDDED -#define CFG_FLASH_ERASE_TOUT 30000 /* Timeout for Chip Erase (in ms) */ -#define CFG_FLASH_ERASEBLOCK_TOUT 5000 /* Timeout for Block Erase (in ms) */ -#define CFG_FLASH_WRITE_TOUT 1 /* Timeout for Flash Write (in ms) */ +#define CONFIG_SYS_FLASH_ERASE_TOUT 30000 /* Timeout for Chip Erase (in ms) */ +#define CONFIG_SYS_FLASH_ERASEBLOCK_TOUT 5000 /* Timeout for Block Erase (in ms) */ +#define CONFIG_SYS_FLASH_WRITE_TOUT 1 /* Timeout for Flash Write (in ms) */ /* JFFS Partition offset set */ -#define CFG_JFFS2_FIRST_BANK 0 -#define CFG_JFFS2_NUM_BANKS 1 +#define CONFIG_SYS_JFFS2_FIRST_BANK 0 +#define CONFIG_SYS_JFFS2_NUM_BANKS 1 /* 512k reserved for u-boot */ -#define CFG_JFFS2_FIRST_SECTOR 11 +#define CONFIG_SYS_JFFS2_FIRST_SECTOR 11 /* * following timeouts shall be used once the * Flash real protection is enabled */ -#define CFG_FLASH_LOCK_TOUT 5 /* Timeout for Flash Set Lock Bit (in ms) */ -#define CFG_FLASH_UNLOCK_TOUT 10000 /* Timeout for Flash Clear Lock Bits (in ms) */ +#define CONFIG_SYS_FLASH_LOCK_TOUT 5 /* Timeout for Flash Set Lock Bit (in ms) */ +#define CONFIG_SYS_FLASH_UNLOCK_TOUT 10000 /* Timeout for Flash Clear Lock Bits (in ms) */ /* * SDRAM settings & memory map @@ -140,27 +140,27 @@ #define CONFIG_MEM_ADD_WDTH 11 /* 8, 9, 10, 11 */ #define CONFIG_MEM_MT48LC64M4A2FB_7E 1 -#define CFG_MEMTEST_START 0x00000000 /* memtest works on */ +#define CONFIG_SYS_MEMTEST_START 0x00000000 /* memtest works on */ -#define CFG_SDRAM_BASE 0x00000000 +#define CONFIG_SYS_SDRAM_BASE 0x00000000 -#define CFG_MAX_RAM_SIZE (CONFIG_MEM_SIZE * 1024 *1024) -#define CFG_MEMTEST_END (CFG_MAX_RAM_SIZE - 0x80000 - 1) +#define CONFIG_SYS_MAX_RAM_SIZE (CONFIG_MEM_SIZE * 1024 *1024) +#define CONFIG_SYS_MEMTEST_END (CONFIG_SYS_MAX_RAM_SIZE - 0x80000 - 1) #define CONFIG_LOADADDR 0x01000000 -#define CFG_LOAD_ADDR CONFIG_LOADADDR -#define CFG_MONITOR_LEN (256 << 10) /* Reserve 256 kB for Monitor */ -#define CFG_MALLOC_LEN (128 << 10) /* Reserve 128 kB for malloc() */ -#define CFG_GBL_DATA_SIZE 0x4000 /* Reserve 16k for Global Data */ +#define CONFIG_SYS_LOAD_ADDR CONFIG_LOADADDR +#define CONFIG_SYS_MONITOR_LEN (256 << 10) /* Reserve 256 kB for Monitor */ +#define CONFIG_SYS_MALLOC_LEN (128 << 10) /* Reserve 128 kB for malloc() */ +#define CONFIG_SYS_GBL_DATA_SIZE 0x4000 /* Reserve 16k for Global Data */ #define CONFIG_STACKSIZE (128*1024) /* regular stack */ -#define CFG_MONITOR_BASE (CFG_MAX_RAM_SIZE - 0x40000) -#define CFG_MALLOC_BASE (CFG_MONITOR_BASE - CFG_MALLOC_LEN) -#define CFG_GBL_DATA_ADDR (CFG_MALLOC_BASE - CFG_GBL_DATA_SIZE) -#define CONFIG_STACKBASE (CFG_GBL_DATA_ADDR - 4) +#define CONFIG_SYS_MONITOR_BASE (CONFIG_SYS_MAX_RAM_SIZE - 0x40000) +#define CONFIG_SYS_MALLOC_BASE (CONFIG_SYS_MONITOR_BASE - CONFIG_SYS_MALLOC_LEN) +#define CONFIG_SYS_GBL_DATA_ADDR (CONFIG_SYS_MALLOC_BASE - CONFIG_SYS_GBL_DATA_SIZE) +#define CONFIG_STACKBASE (CONFIG_SYS_GBL_DATA_ADDR - 4) /* Check to make sure everything fits in SDRAM */ -#if ((CFG_MONITOR_BASE + CFG_MONITOR_LEN) > CFG_MAX_RAM_SIZE) +#if ((CONFIG_SYS_MONITOR_BASE + CONFIG_SYS_MONITOR_LEN) > CONFIG_SYS_MAX_RAM_SIZE) #error Memory Map does not fit into configuration #endif @@ -182,10 +182,10 @@ * Command settings */ -#define CFG_LONGHELP 1 +#define CONFIG_SYS_LONGHELP 1 #define CONFIG_CMDLINE_EDITING 1 -#define CFG_AUTOLOAD "no" /*rarpb, bootp or dhcp commands will perform only a */ +#define CONFIG_SYS_AUTOLOAD "no" /*rarpb, bootp or dhcp commands will perform only a */ /* configuration lookup from the BOOTP/DHCP server, */ /* but not try to load any image using TFTP */ @@ -256,18 +256,18 @@ */ #define CONFIG_BAUDRATE 57600 -#define CFG_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 } +#define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 } -#define CFG_PROMPT "bfin> " /* Monitor Command Prompt */ +#define CONFIG_SYS_PROMPT "bfin> " /* Monitor Command Prompt */ #if defined(CONFIG_CMD_KGDB) -#define CFG_CBSIZE 1024 /* Console I/O Buffer Size */ +#define CONFIG_SYS_CBSIZE 1024 /* Console I/O Buffer Size */ #else -#define CFG_CBSIZE 256 /* Console I/O Buffer Size */ +#define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */ #endif -#define CFG_PBSIZE (CFG_CBSIZE+sizeof(CFG_PROMPT)+16) /* Print Buffer Size */ -#define CFG_MAXARGS 16 /* max number of command args */ -#define CFG_BARGSIZE CFG_CBSIZE /* Boot Argument Buffer Size */ +#define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */ +#define CONFIG_SYS_MAXARGS 16 /* max number of command args */ +#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */ #define CONFIG_LOADS_ECHO 1 @@ -299,8 +299,8 @@ } #define I2C_DELAY udelay(5) /* 1/4 I2C clock duration */ -#define CFG_I2C_SPEED 50000 -#define CFG_I2C_SLAVE 0xFE +#define CONFIG_SYS_I2C_SPEED 50000 +#define CONFIG_SYS_I2C_SLAVE 0xFE #endif /* CONFIG_SOFT_I2C */ /* @@ -321,26 +321,26 @@ #undef CONFIG_IDE_LED /* no led for ide supported */ #undef CONFIG_IDE_RESET /* no reset for ide supported */ -#define CFG_IDE_MAXBUS 1 /* max. 1 IDE busses */ -#define CFG_IDE_MAXDEVICE (CFG_IDE_MAXBUS*1) /* max. 1 drives per IDE bus */ +#define CONFIG_SYS_IDE_MAXBUS 1 /* max. 1 IDE busses */ +#define CONFIG_SYS_IDE_MAXDEVICE (CONFIG_SYS_IDE_MAXBUS*1) /* max. 1 drives per IDE bus */ -#define CFG_ATA_BASE_ADDR 0x20200000 -#define CFG_ATA_IDE0_OFFSET 0x0000 +#define CONFIG_SYS_ATA_BASE_ADDR 0x20200000 +#define CONFIG_SYS_ATA_IDE0_OFFSET 0x0000 -#define CFG_ATA_DATA_OFFSET 0x0020 /* Offset for data I/O */ -#define CFG_ATA_REG_OFFSET 0x0020 /* Offset for normal register accesses */ -#define CFG_ATA_ALT_OFFSET 0x0007 /* Offset for alternate registers */ +#define CONFIG_SYS_ATA_DATA_OFFSET 0x0020 /* Offset for data I/O */ +#define CONFIG_SYS_ATA_REG_OFFSET 0x0020 /* Offset for normal register accesses */ +#define CONFIG_SYS_ATA_ALT_OFFSET 0x0007 /* Offset for alternate registers */ -#define CFG_ATA_STRIDE 2 +#define CONFIG_SYS_ATA_STRIDE 2 #endif /* * Miscellaneous configurable options */ -#define CFG_HZ 1000 /* 1ms time tick */ +#define CONFIG_SYS_HZ 1000 /* 1ms time tick */ -#define CFG_BOOTM_LEN 0x4000000/* Large Image Length, set to 64 Meg */ +#define CONFIG_SYS_BOOTM_LEN 0x4000000/* Large Image Length, set to 64 Meg */ #define CONFIG_SHOW_BOOT_PROGRESS 1 /* Show boot progress on LEDs */ |