diff options
Diffstat (limited to 'include/linux/pruss_driver.h')
| -rw-r--r-- | include/linux/pruss_driver.h | 227 |
1 files changed, 227 insertions, 0 deletions
diff --git a/include/linux/pruss_driver.h b/include/linux/pruss_driver.h new file mode 100644 index 00000000000..25272e850e0 --- /dev/null +++ b/include/linux/pruss_driver.h @@ -0,0 +1,227 @@ +/* SPDX-License-Identifier: GPL-2.0+ */ + +#ifndef __TI_PRUSS_H +#define __TI_PRUSS_H + +/* + * PRU_ICSS_CFG registers + * SYSCFG, ISRP, ISP, IESP, IECP, SCRP applicable on AMxxxx devices only + */ +#define PRUSS_CFG_REVID 0x00 +#define PRUSS_CFG_SYSCFG 0x04 +#define PRUSS_CFG_GPCFG(x) (0x08 + (x) * 4) +#define PRUSS_CFG_CGR 0x10 +#define PRUSS_CFG_ISRP 0x14 +#define PRUSS_CFG_ISP 0x18 +#define PRUSS_CFG_IESP 0x1C +#define PRUSS_CFG_IECP 0x20 +#define PRUSS_CFG_SCRP 0x24 +#define PRUSS_CFG_PMAO 0x28 +#define PRUSS_CFG_MII_RT 0x2C +#define PRUSS_CFG_IEPCLK 0x30 +#define PRUSS_CFG_SPP 0x34 +#define PRUSS_CFG_PIN_MX 0x40 + +/* PRUSS_GPCFG register bits */ +#define PRUSS_GPCFG_PRU_GPO_SH_SEL BIT(25) + +#define PRUSS_GPCFG_PRU_DIV1_SHIFT 20 +#define PRUSS_GPCFG_PRU_DIV1_MASK GENMASK(24, 20) + +#define PRUSS_GPCFG_PRU_DIV0_SHIFT 15 +#define PRUSS_GPCFG_PRU_DIV0_MASK GENMASK(15, 19) + +#define PRUSS_GPCFG_PRU_GPO_MODE BIT(14) +#define PRUSS_GPCFG_PRU_GPO_MODE_DIRECT 0 +#define PRUSS_GPCFG_PRU_GPO_MODE_SERIAL BIT(14) + +#define PRUSS_GPCFG_PRU_GPI_SB BIT(13) + +#define PRUSS_GPCFG_PRU_GPI_DIV1_SHIFT 8 +#define PRUSS_GPCFG_PRU_GPI_DIV1_MASK GENMASK(12, 8) + +#define PRUSS_GPCFG_PRU_GPI_DIV0_SHIFT 3 +#define PRUSS_GPCFG_PRU_GPI_DIV0_MASK GENMASK(7, 3) + +#define PRUSS_GPCFG_PRU_GPI_CLK_MODE_POSITIVE 0 +#define PRUSS_GPCFG_PRU_GPI_CLK_MODE_NEGATIVE BIT(2) +#define PRUSS_GPCFG_PRU_GPI_CLK_MODE BIT(2) + +#define PRUSS_GPCFG_PRU_GPI_MODE_MASK GENMASK(1, 0) +#define PRUSS_GPCFG_PRU_GPI_MODE_SHIFT 0 + +#define PRUSS_GPCFG_PRU_MUX_SEL_SHIFT 26 +#define PRUSS_GPCFG_PRU_MUX_SEL_MASK GENMASK(29, 26) + +/* PRUSS_MII_RT register bits */ +#define PRUSS_MII_RT_EVENT_EN BIT(0) + +/* PRUSS_SPP register bits */ +#define PRUSS_SPP_PRU1_PAD_HP_EN BIT(0) +#define PRUSS_SPP_XFER_SHIFT_EN BIT(1) +#define PRUSS_SPP_XFR_BYTE_SHIFT_EN BIT(2) +#define PRUSS_SPP_RTU_XFR_SHIFT_EN BIT(3) + +/** + * enum pruss_gp_mux_sel - PRUSS GPI/O Mux modes for the + * PRUSS_GPCFG0/1 registers + * + * NOTE: The below defines are the most common values, but there + * are some exceptions like on 66AK2G, where the RESERVED and MII2 + * values are interchanged. Also, this bit-field does not exist on + * AM335x SoCs + */ +enum pruss_gp_mux_sel { + PRUSS_GP_MUX_SEL_GP = 0, + PRUSS_GP_MUX_SEL_ENDAT, + PRUSS_GP_MUX_SEL_RESERVED, + PRUSS_GP_MUX_SEL_SD, + PRUSS_GP_MUX_SEL_MII2, + PRUSS_GP_MUX_SEL_MAX, +}; + +/** + * enum pruss_gpi_mode - PRUSS GPI configuration modes, used + * to program the PRUSS_GPCFG0/1 registers + */ +enum pruss_gpi_mode { + PRUSS_GPI_MODE_DIRECT = 0, + PRUSS_GPI_MODE_PARALLEL, + PRUSS_GPI_MODE_28BIT_SHIFT, + PRUSS_GPI_MODE_MII, +}; + +/** + * enum pruss_pru_id - PRU core identifiers + */ +enum pruss_pru_id { + PRUSS_PRU0 = 0, + PRUSS_PRU1, + PRUSS_NUM_PRUS, +}; + +/** + * enum pru_ctable_idx - Configurable Constant table index identifiers + */ +enum pru_ctable_idx { + PRU_C24 = 0, + PRU_C25, + PRU_C26, + PRU_C27, + PRU_C28, + PRU_C29, + PRU_C30, + PRU_C31, +}; + +/** + * enum pruss_mem - PRUSS memory range identifiers + */ +enum pruss_mem { + PRUSS_MEM_DRAM0 = 0, + PRUSS_MEM_DRAM1, + PRUSS_MEM_SHRD_RAM2, + PRUSS_MEM_MAX, +}; + +/** + * struct pruss_mem_region - PRUSS memory region structure + * @va: kernel virtual address of the PRUSS memory region + * @pa: physical (bus) address of the PRUSS memory region + * @size: size of the PRUSS memory region + */ +struct pruss_mem_region { + void __iomem *va; + phys_addr_t pa; + size_t size; +}; + +/** + * struct pruss - PRUSS parent structure + * @dev: pruss device pointer + * @cfg: regmap for config region + * @mem_regions: data for each of the PRUSS memory regions + * @mem_in_use: to indicate if memory resource is in use + */ +struct pruss { + struct udevice *dev; + struct regmap *cfg; + struct pruss_mem_region mem_regions[PRUSS_MEM_MAX]; + struct pruss_mem_region *mem_in_use[PRUSS_MEM_MAX]; +}; + +int pruss_request_tm_region(struct udevice *dev, phys_addr_t *loc); +int pruss_request_mem_region(struct udevice *dev, enum pruss_mem mem_id, + struct pruss_mem_region *region); +int pruss_release_mem_region(struct udevice *dev, struct pruss_mem_region *region); +int pruss_cfg_update(struct udevice *dev, unsigned int reg, + unsigned int mask, unsigned int val); + +/** + * pruss_cfg_gpimode() - set the GPI mode of the PRU + * @dev: the pruss device + * @pru_id: the rproc instance handle of the PRU + * @mode: GPI mode to set + * + * Sets the GPI mode for a given PRU by programming the + * corresponding PRUSS_CFG_GPCFGx register + * + * Returns 0 on success, or an error code otherwise + */ +static inline int pruss_cfg_gpimode(struct udevice *dev, enum pruss_pru_id id, + enum pruss_gpi_mode mode) +{ + if (id < 0) + return -EINVAL; + + return pruss_cfg_update(dev, PRUSS_CFG_GPCFG(id), + PRUSS_GPCFG_PRU_GPI_MODE_MASK, + mode << PRUSS_GPCFG_PRU_GPI_MODE_SHIFT); +} + +/** + * pruss_cfg_miirt_enable() - Enable/disable MII RT Events + * @dev: the pruss device + * @enable: enable/disable + * + * Enable/disable the MII RT Events for the PRUSS. + */ +static inline int pruss_cfg_miirt_enable(struct udevice *dev, bool enable) +{ + u32 set = enable ? PRUSS_MII_RT_EVENT_EN : 0; + + return pruss_cfg_update(dev, PRUSS_CFG_MII_RT, + PRUSS_MII_RT_EVENT_EN, set); +} + +/** + * pruss_cfg_xfr_enable() - Enable/disable XIN XOUT shift functionality + * @dev: the pruss device + * @enable: enable/disable + */ +static inline int pruss_cfg_xfr_enable(struct udevice *dev, bool enable) +{ + u32 set = enable ? PRUSS_SPP_XFER_SHIFT_EN : 0; + + return pruss_cfg_update(dev, PRUSS_CFG_SPP, + PRUSS_SPP_XFER_SHIFT_EN, set); +} + +/** + * pruss_cfg_set_gpmux() - set the GPMUX value for a PRU device + * @pruss: pruss device + * @pru_id: PRU identifier (0-1) + * @mux: new mux value for PRU + */ +static inline int pruss_cfg_set_gpmux(struct udevice *dev, + enum pruss_pru_id id, u8 mux) +{ + if (mux >= PRUSS_GP_MUX_SEL_MAX) + return -EINVAL; + + return pruss_cfg_update(dev, PRUSS_CFG_GPCFG(id), + PRUSS_GPCFG_PRU_MUX_SEL_MASK, + (u32)mux << PRUSS_GPCFG_PRU_MUX_SEL_SHIFT); +} + +#endif /* __TI_PRUSS_H */ |