summaryrefslogtreecommitdiff
AgeCommit message (Expand)Author
2018-11-27colibri_imx7: explicitly set flash detection pin as inputStefan Agner
2018-11-27colibri_imx7: fix comments about memory alignment requirementsStefan Agner
2018-09-28toradex boards: sdboot cosmetic clean-upColibri-iMX7_LXDE-Image_2.8b4.129-20181005Colibri-iMX6_LXDE-Image_2.8b4.129-20181005Colibri-iMX6ULL_LXDE-Image_2.8b4.129-20181005Colibri-VF_LXDE-Image_2.8b4.129-20181005Colibri-T30_LXDE-Image_2.8b4.129-20181005Colibri-T20_LXDE-Image_2.8b4.129-20181005Apalis-iMX6_LXDE-Image_2.8b4.129-20181005Apalis-TK1_LXDE-Image_2.8b4.129-20181005Apalis-TK1-Mainline_LXDE-Image_2.8b4.129-20181005Apalis-T30_LXDE-Image_2.8b4.129-20181005Marcel Ziswiler
2018-09-28colibri_t20: fix sdbootMarcel Ziswiler
2018-09-28Revert "apalis-tk1: change usb_port_owner_info to 3 in defargs"Dominik Sliwa
2018-09-28colibri-imx6ull: fix ethernet phy power onMarcel Ziswiler
2018-09-28colibri imx6: use dynamic ddr calibrationMax Krummenacher
2018-09-27mx6: ddr: use consistent debug outputMax Krummenacher
2018-09-20ARM: mx6: ddr: use Kconfig for inclusion of DDR calibration routinesEric Nelson
2018-09-20mx6: ddr: add routine to return DDR calibration dataEric Nelson
2018-09-20mx6: ddr: pass mx6_ddr_sysinfo to calibration routinesEric Nelson
2018-09-20mx6: ddr: allow 32 cycles for DQS gating calibrationEric Nelson
2018-09-20colibri_imx6: apply nreset_out only if no power-onStefan Bigler
2018-09-20mtd: nand: colibri_t20: more comments/debug outputMarcel Ziswiler
2018-09-13imx: imx-common: do not zero out outside of regionsStefan Agner
2018-09-13colibri_vf: Fix sdboot in vf modulesGerard Salvatella
2018-09-13board: toradex: turn off lcd backlight before OS handoverGerard Salvatella
2018-09-13common: add board specific hook for os pre-boot configGerard Salvatella
2018-09-13board: apalis/colibri_imx6: check for and report ecc errors in fusesGerard Salvatella
2018-07-27apalis-tk1: remove non-esential power rails on bootDominik Sliwa
2018-07-27apalis/colibri_imx6/imx6ull: make sure loadaddr does not collideStefan Agner
2018-07-27apalis_t30: integrate tezi recoveryMarcel Ziswiler
2018-07-27apalis_t30: add configuration for teziMarcel Ziswiler
2018-07-27apalis-tk1: integrate tezi recoveryMarcel Ziswiler
2018-07-27apalis-tk1: add configuration for teziMarcel Ziswiler
2018-07-27colibri-imx6ull: add configuration for teziStefan Agner
2018-07-27colibri_imx7: add configuration for tezi recoveryStefan Agner
2018-07-27colibri_imx7_emmc: add configuration for teziStefan Agner
2018-07-27colibri_imx7: add configuration for teziStefan Agner
2018-07-27mtest: disable physical memory cell test for teziStefan Agner
2018-07-27colibri_imx6: add configuration for teziStefan Agner
2018-07-27apalis_imx6: add configuration for teziStefan Agner
2018-07-27toradex: add easy installer configurabilityMarcel Ziswiler
2018-07-27colibri_imx7_emmc: legacy update from external sd cardStefan Eichenberger
2018-06-19apalis-tk1: apalis_t30: colibri_t30: display reset reasonColibri-iMX7_LXDE-Image_2.8b3.111-20180627Colibri-iMX6_LXDE-Image_2.8b3.111-20180627Colibri-iMX6ULL_LXDE-Image_2.8b3.111-20180627Colibri-VF_LXDE-Image_2.8b3.111-20180626Colibri-T30_LXDE-Image_2.8b3.111-20180627Colibri-T20_LXDE-Image_2.8b3.111-20180626Apalis-iMX6_LXDE-Image_2.8b3.111-20180626Apalis-TK1_LXDE-Image_2.8b3.111-20180626Apalis-TK1-Mainline_LXDE-Image_2.8b3.111-20180627Apalis-T30_LXDE-Image_2.8b3.111-20180626Dominik Sliwa
2018-06-19apalis-tk1: invoking ram_repair before powerup_cpus()Dominik Sliwa
2018-06-19colibri-imx6ull: set module variant depending on config blockStefan Agner
2018-06-19tdx-cfg-block: simplify i.MX 6 module detectionStefan Agner
2018-06-18tdx-cfg-block: add support for new Colibri iMX6ULL SKUsGerard Salvatella
2018-06-18colibri_imx7_emmc: add fatwrite supportGerard Salvatella
2018-06-18colibri-vf: use leveling evaluated by DDR validation toolsStefan Agner
2018-06-18colibri-vf: adjust timing according to data sheetStefan Agner
2018-06-06ARM: vf610: ddrmc: do not write CR79 by defaultStefan Agner
2018-06-06ARM: vf610: ddrmc: fix CR138 preprocessor defineStefan Agner
2018-06-06ARM: vf610: fix initialization completion detectionStefan Agner
2018-06-06arm: vf610: add UART2 pinmux/clock supportStefan Agner
2018-06-06colibri-imx6: added nreset gpio on rebootGerard Salvatella
2018-06-06cmd: ubi: print load size after establishing volume sizeStefan Agner
2018-06-06cmd: set filesize variable in ubi readHolger Dengler
2018-06-06colibri-imx6ull: fix card detect GPIO of SD cardStefan Agner
generated by cgit v1.2.3 (git 2.0.4) at 2024-11-01 02:22:25 +0000