Age | Commit message (Collapse) | Author |
|
Adding update fusing command to assist in updating modules to the fast
boot mode as per the following article on our developer website:
http://developer.toradex.com/knowledge-base/linux-booting#eMMC_Fast_Boot_Mode_ApalisColibri_iMX6
Signed-off-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
Acked-by: Max Krummenacher <max.krummenacher@toradex.com>
|
|
Signed-off-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
Acked-by: Max Krummenacher <max.krummenacher@toradex.com>
|
|
Signed-off-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
Acked-by: Max Krummenacher <max.krummenacher@toradex.com>
|
|
Signed-off-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
Acked-by: Max Krummenacher <max.krummenacher@toradex.com>
|
|
Currently a divider of 6 has been used, leading to following NAND
Flash Controller (NFC) clocks:
VF61: 27.7 MHz (166.7MHz bus clock)
VF50: 22 MHz (132MHz bus clock)
The NAND Flash Memory used on VF50 allows to use clock speed of
up to 33MHz, while the Flash Memory of VF61 allows 50MHz. We can
use the same divider of 4 on both modules to configure the maximal
possible clock speeds:
VF61: 41.7 MHz
VF50: 33 MHz
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
Acked-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
|
|
Configure the Ricoh PMIC RN5T567 at startup to reset the board
without delay.
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
Acked-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
|
|
Add power driver for Ricoh PMIC used on Colibri iMX7.
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
Acked-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
|
|
With the next release our update scripts write the kernel and
device tree in seperate UBI volumes. This allows to use a lot
less UBI/UBIFS support in U-Boot, which should lower the risk
of hitting bugs in this area. Boot times are also slightly
faster (measurements showed an improvement of ~150ms).
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
This reverts commit c31a8b2bdb47dc8fa71c259423bd8fed840b8a25.
The introduction of a union results in correct alignment.
The additional reserved word now misaligns the structure again.
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
Conflicts:
tools/imximage.h
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Updated regulator naming in device tree as discussed with Stefan
earlier.
Signed-off-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Cap product id to avoid issues with a yet unknown one.
Signed-off-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
As we now have the configblock handling the MAC address is set
from the configblock.
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Used during manufacturing for setting the boot fuses.
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
While at it fix whitespace issue.
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
While at it remove unusable boot modes from the list.
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
This lives now in colibri_imx7_defconfig
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Code mostly ported from imx-kobs-5.3.
MTD partitioning is set accordingly.
writebcb: Write Boot Control Block (FCB and DBBT)
writeboot: Write bootloadder
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Modification taken from imx-kobs-5.3.
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
We need raw nand access to write the fcb in cmd_writebcb_mx7.
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
All fsl boards use this when booting from NAND.
While at it minimize it with savedefconfig.
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Add pinmux and I2C setup call to register the Colibri I2C bus.
The fourth (I2C4) instance is used for the I2C bus defined in the
standard Colibri pinout. Use i2c dev 3 to switch to this bus.
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
|
|
Note that this input mux seems to be missing in the current
reference manual, but has been proven to be working on actual
hardware.
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
|
|
HW patch required. Connect RMII_CRS_DV - ENET1_RXC, remove R166
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
kobs-ng needs a partition which holds FCB, DBBT, and Bootloader,
not FCB, DBBT alone.
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Output 50MHz reference clock works, sending works but no reception.
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|
|
Signed-off-by: Max Krummenacher <max.krummenacher@toradex.com>
Signed-off-by: Stefan Agner <stefan.agner@toradex.com>
|