index
:
u-boot-toradex.git
2011.12-colibri_vf
2014.04-toradex
2014.10-toradex
2014.10-toradex-next
2015.04-imx7-1.1.0_ga-toradex-next
2015.04-toradex
2015.04-toradex-next
2016.11-toradex
2016.11-toradex-next
colibri
colibri-next
colibri_vf
toradex_2019.07
toradex_2019.07-next
toradex_2020.07
toradex_imx6
toradex_imx_lf_v2022.04
toradex_imx_lf_v2024.04
toradex_imx_v2017.03_4.9.123_imx8mm_ga-bring_up
toradex_imx_v2017.03_4.9.51_imx8_beta1-bring_up
toradex_imx_v2017.03_4.9.51_imx8_beta2-bring_up
toradex_imx_v2018.03_4.14.62_1.0.0_beta-bringup
toradex_imx_v2018.03_4.14.78_1.0.0_ga-bringup
toradex_imx_v2018.03_4.14.98_2.3.0_bringup
toradex_imx_v2020.04_5.4.24_2.1.0
toradex_imx_v2020.04_5.4.70_2.3.0
toradex_ti-u-boot-2021.01_bringup
toradex_ti-u-boot-2023.04
toradex_ti-u-boot-2024.04
U-Boot bootloader for Apalis and Colibri modules
Toradex
summary
refs
log
tree
commit
diff
log msg
author
committer
range
Age
Commit message (
Expand
)
Author
2018-12-20
apalis-tk1: remove default vesa vga mode from vidargs
Colibri-iMX7_LXDE-Image_2.8b5.156-20181228
Colibri-iMX6_LXDE-Image_2.8b5.156-20181228
Colibri-iMX6ULL_LXDE-Image_2.8b5.156-20181228
Colibri-VF_LXDE-Image_2.8b5.156-20181228
Colibri-T30_LXDE-Image_2.8b5.156-20181228
Colibri-T20_LXDE-Image_2.8b5.156-20181228
Apalis-iMX6_LXDE-Image_2.8b5.156-20181228
Apalis-TK1_LXDE-Image_2.8b5.156-20181228
Apalis-TK1-Mainline_LXDE-Image_2.8b5.156-20181228
Apalis-T30_LXDE-Image_2.8b5.156-20181228
Marcel Ziswiler
2018-12-20
colibri_imx7_emmc: fix kernel freeze if M4 started from U-Boot
Marcel Ziswiler
2018-12-20
colibri_imx7: fix kernel freeze if M4 started from U-Boot
Marcel Ziswiler
2018-12-20
mx6: toradex: apalis_imx6: increase phy autonegotiation timeout
Marcel Ziswiler
2018-12-20
phy: ksz9031: Center FLP timing at 16ms
Philippe Schenker
2018-12-20
board: imx6ull: Add disable PMIC_STBY_REQ
Philippe Schenker
2018-11-27
colibri_imx7: explicitly set flash detection pin as input
Stefan Agner
2018-11-27
colibri_imx7: fix comments about memory alignment requirements
Stefan Agner
2018-09-28
toradex boards: sdboot cosmetic clean-up
Colibri-iMX7_LXDE-Image_2.8b4.129-20181005
Colibri-iMX6_LXDE-Image_2.8b4.129-20181005
Colibri-iMX6ULL_LXDE-Image_2.8b4.129-20181005
Colibri-VF_LXDE-Image_2.8b4.129-20181005
Colibri-T30_LXDE-Image_2.8b4.129-20181005
Colibri-T20_LXDE-Image_2.8b4.129-20181005
Apalis-iMX6_LXDE-Image_2.8b4.129-20181005
Apalis-TK1_LXDE-Image_2.8b4.129-20181005
Apalis-TK1-Mainline_LXDE-Image_2.8b4.129-20181005
Apalis-T30_LXDE-Image_2.8b4.129-20181005
Marcel Ziswiler
2018-09-28
colibri_t20: fix sdboot
Marcel Ziswiler
2018-09-28
Revert "apalis-tk1: change usb_port_owner_info to 3 in defargs"
Dominik Sliwa
2018-09-28
colibri-imx6ull: fix ethernet phy power on
Marcel Ziswiler
2018-09-28
colibri imx6: use dynamic ddr calibration
Max Krummenacher
2018-09-27
mx6: ddr: use consistent debug output
Max Krummenacher
2018-09-20
ARM: mx6: ddr: use Kconfig for inclusion of DDR calibration routines
Eric Nelson
2018-09-20
mx6: ddr: add routine to return DDR calibration data
Eric Nelson
2018-09-20
mx6: ddr: pass mx6_ddr_sysinfo to calibration routines
Eric Nelson
2018-09-20
mx6: ddr: allow 32 cycles for DQS gating calibration
Eric Nelson
2018-09-20
colibri_imx6: apply nreset_out only if no power-on
Stefan Bigler
2018-09-20
mtd: nand: colibri_t20: more comments/debug output
Marcel Ziswiler
2018-09-13
imx: imx-common: do not zero out outside of regions
Stefan Agner
2018-09-13
colibri_vf: Fix sdboot in vf modules
Gerard Salvatella
2018-09-13
board: toradex: turn off lcd backlight before OS handover
Gerard Salvatella
2018-09-13
common: add board specific hook for os pre-boot config
Gerard Salvatella
2018-09-13
board: apalis/colibri_imx6: check for and report ecc errors in fuses
Gerard Salvatella
2018-07-27
apalis-tk1: remove non-esential power rails on boot
Dominik Sliwa
2018-07-27
apalis/colibri_imx6/imx6ull: make sure loadaddr does not collide
Stefan Agner
2018-07-27
apalis_t30: integrate tezi recovery
Marcel Ziswiler
2018-07-27
apalis_t30: add configuration for tezi
Marcel Ziswiler
2018-07-27
apalis-tk1: integrate tezi recovery
Marcel Ziswiler
2018-07-27
apalis-tk1: add configuration for tezi
Marcel Ziswiler
2018-07-27
colibri-imx6ull: add configuration for tezi
Stefan Agner
2018-07-27
colibri_imx7: add configuration for tezi recovery
Stefan Agner
2018-07-27
colibri_imx7_emmc: add configuration for tezi
Stefan Agner
2018-07-27
colibri_imx7: add configuration for tezi
Stefan Agner
2018-07-27
mtest: disable physical memory cell test for tezi
Stefan Agner
2018-07-27
colibri_imx6: add configuration for tezi
Stefan Agner
2018-07-27
apalis_imx6: add configuration for tezi
Stefan Agner
2018-07-27
toradex: add easy installer configurability
Marcel Ziswiler
2018-07-27
colibri_imx7_emmc: legacy update from external sd card
Stefan Eichenberger
2018-06-19
apalis-tk1: apalis_t30: colibri_t30: display reset reason
Colibri-iMX7_LXDE-Image_2.8b3.111-20180627
Colibri-iMX6_LXDE-Image_2.8b3.111-20180627
Colibri-iMX6ULL_LXDE-Image_2.8b3.111-20180627
Colibri-VF_LXDE-Image_2.8b3.111-20180626
Colibri-T30_LXDE-Image_2.8b3.111-20180627
Colibri-T20_LXDE-Image_2.8b3.111-20180626
Apalis-iMX6_LXDE-Image_2.8b3.111-20180626
Apalis-TK1_LXDE-Image_2.8b3.111-20180626
Apalis-TK1-Mainline_LXDE-Image_2.8b3.111-20180627
Apalis-T30_LXDE-Image_2.8b3.111-20180626
Dominik Sliwa
2018-06-19
apalis-tk1: invoking ram_repair before powerup_cpus()
Dominik Sliwa
2018-06-19
colibri-imx6ull: set module variant depending on config block
Stefan Agner
2018-06-19
tdx-cfg-block: simplify i.MX 6 module detection
Stefan Agner
2018-06-18
tdx-cfg-block: add support for new Colibri iMX6ULL SKUs
Gerard Salvatella
2018-06-18
colibri_imx7_emmc: add fatwrite support
Gerard Salvatella
2018-06-18
colibri-vf: use leveling evaluated by DDR validation tools
Stefan Agner
2018-06-18
colibri-vf: adjust timing according to data sheet
Stefan Agner
2018-06-06
ARM: vf610: ddrmc: do not write CR79 by default
Stefan Agner
2018-06-06
ARM: vf610: ddrmc: fix CR138 preprocessor define
Stefan Agner
[next]