From d2c05f50e12f87128597a28146de7092aaa847c3 Mon Sep 17 00:00:00 2001 From: Faiz Abbas Date: Fri, 5 Apr 2019 14:18:46 +0530 Subject: mmc: omap_hsmmc: Set 3.3V for IO voltage Pbias voltage should match the IO voltage set for the SD card. With the latest pbias change to 3.3V, update the capabilities and IO voltages settings to 3.3V. Signed-off-by: Faiz Abbas --- drivers/mmc/omap_hsmmc.c | 21 ++++++++++----------- 1 file changed, 10 insertions(+), 11 deletions(-) (limited to 'drivers/mmc') diff --git a/drivers/mmc/omap_hsmmc.c b/drivers/mmc/omap_hsmmc.c index 826a39fad72..133cdc13527 100644 --- a/drivers/mmc/omap_hsmmc.c +++ b/drivers/mmc/omap_hsmmc.c @@ -264,7 +264,7 @@ static unsigned char mmc_board_init(struct mmc *mmc) !CONFIG_IS_ENABLED(DM_REGULATOR) /* PBIAS config needed for MMC1 only */ if (mmc_get_blk_desc(mmc)->devnum == 0) - vmmc_pbias_config(LDO_VOLT_3V0); + vmmc_pbias_config(LDO_VOLT_3V3); #endif return 0; @@ -418,7 +418,7 @@ static void omap_hsmmc_conf_bus_power(struct mmc *mmc, uint signal_voltage) switch (signal_voltage) { case MMC_SIGNAL_VOLTAGE_330: - hctl |= SDVS_3V0; + hctl |= SDVS_3V3; break; case MMC_SIGNAL_VOLTAGE_180: hctl |= SDVS_1V8; @@ -514,10 +514,9 @@ static int omap_hsmmc_set_signal_voltage(struct mmc *mmc) return -EINVAL; if (mmc->signal_voltage == MMC_SIGNAL_VOLTAGE_330) { - /* Use 3.0V rather than 3.3V */ - mv = 3000; - capa_mask = VS30_3V0SUP; - palmas_ldo_volt = LDO_VOLT_3V0; + mv = 3300; + capa_mask = VS33_3V3SUP; + palmas_ldo_volt = LDO_VOLT_3V3; } else if (mmc->signal_voltage == MMC_SIGNAL_VOLTAGE_180) { capa_mask = VS18_1V8SUP; palmas_ldo_volt = LDO_VOLT_1V8; @@ -556,13 +555,13 @@ static uint32_t omap_hsmmc_set_capabilities(struct mmc *mmc) val = readl(&mmc_base->capa); if (priv->controller_flags & OMAP_HSMMC_SUPPORTS_DUAL_VOLT) { - val |= (VS30_3V0SUP | VS18_1V8SUP); + val |= (VS33_3V3SUP | VS18_1V8SUP); } else if (priv->controller_flags & OMAP_HSMMC_NO_1_8_V) { - val |= VS30_3V0SUP; + val |= VS33_3V3SUP; val &= ~VS18_1V8SUP; } else { val |= VS18_1V8SUP; - val &= ~VS30_3V0SUP; + val &= ~VS33_3V3SUP; } writel(val, &mmc_base->capa); @@ -842,11 +841,11 @@ static int omap_hsmmc_init_setup(struct mmc *mmc) #if CONFIG_IS_ENABLED(DM_MMC) reg_val = omap_hsmmc_set_capabilities(mmc); - omap_hsmmc_conf_bus_power(mmc, (reg_val & VS30_3V0SUP) ? + omap_hsmmc_conf_bus_power(mmc, (reg_val & VS33_3V3SUP) ? MMC_SIGNAL_VOLTAGE_330 : MMC_SIGNAL_VOLTAGE_180); #else writel(DTW_1_BITMODE | SDBP_PWROFF | SDVS_3V0, &mmc_base->hctl); - writel(readl(&mmc_base->capa) | VS30_3V0SUP | VS18_1V8SUP, + writel(readl(&mmc_base->capa) | VS33_3V3SUP | VS18_1V8SUP, &mmc_base->capa); #endif -- cgit v1.2.3