scsi: qla2xxx: target: Add back SRR support

Background: loading qla2xxx with "ql2xtgt_tape_enable=1" enables
Sequence Level Error Recovery (SLER), which is most commonly used for
tape drives.  With SLER enabled, if there is a recoverable I/O error
during a SCSI command, a Sequence Retransmission Request (SRR) will be
used to retry the I/O at a low-level completely within the driver
without propagating the error to the upper levels of the SCSI stack.

SRR support was removed in 2017 by commit 2c39b5ca2a8c ("qla2xxx: Remove
SRR code"). Add it back, new and improved.

The old removed SRR code used sequence numbers to correlate the SRR
CTIOs with SRR immediate notify messages.  I don't see how that would
work reliably with MSI-X interrupts and multiple queues.  So instead use
the exchange address to find the command associated with the immediate
notify (qlt_srr_to_cmd).

The old removed SRR code had a function qlt_check_srr_debug() to
simulate a SRR, but it didn't work for me.  Instead I just used fiber
optic attenuators attached to the FC cable to reduce the strength of the
signal and induce errors.  Unfortunately this only worked for inducing
SRRs on Data-Out (write) commands, so that is all I was able to test.

The code to build a new scatterlist for a SRR with nonzero offset has
been improved to reduce memory requirements and has been well-tested.
However it does not support protection information.

When a single cmd gets multiple SRRs, the old removed SRR code would
restore the data buffer from the values in cmd->se_cmd before processing
the new SRR.  That might be needed if the offset for the new SRR was
lower than the offset for the previous SRR, but I am not sure if that
can happen.  In my testing, when a single cmd gets multiple SRRs, the
SRR offset always increases or stays the same.  But in case it can
decrease, I added the function qlt_restore_orig_sg().  If this is not
supposed to happen then qlt_restore_orig_sg() can be removed to simplify
the code.

I ran into some HBA firmware bugs with QLE269x, QLE27xx, and QLE28xx
firmware 9.05.xx - 9.08.xx where a SRR would cause the HBA to misbehave
badly.  Since SRRs are rare and therefore difficult to test, I figured
it would be worth checking for the buggy firmware and disabling SLER
with a warning instead of letting others run into the same problem on
the rare occasion that they get a SRR.  This turned out to be difficult
because the firmware version isn't known in the normal NVRAM config
routine, so I added a second NVRAM config routine that is called after
the firmware version is known.

Signed-off-by: Tony Battersby <tonyb@cybernetics.com>
Link: https://patch.msgid.link/654b7181-b79e-40ed-a15b-6d6e441a5d5f@cybernetics.com
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

0 files changed, 0 insertions, 0 deletions