Merge tag 'omap-for-v4.1/wl12xx-dt' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap into next/dt

Merge "wireless wl12xx and omap device tree changes for v4.1" from Tony
Lindgren:

Wireless and omap changes to make wl12xx driver to use device tree
data instead of platform data from Eliad Peller <eliad@wizery.com>:

- Add device-tree support to the wlcore (wl12xx/wl18xx) driver.

- Update the current users to use the bindings instead of pdata-quirks.

- Finally, remove the deprecated wl12xx_platform_data struct

Note that da850 board file code that still uses the platform data,
but we have da850.dtsi that can be used instead. So it was decided
that we should try to remove the wl12xx support from the da850
board file as suggested by Sekhar Nori <nsekhar@ti.com>. As it's
the last patch in the series, the last patch can be simply reverted
if needed.

As this series touches quite a bit of arch code, it was suggested
by Kalle Valo <kvalo@codeaurora.org> that the whole series should
be merged via the arm-soc tree.

* tag 'omap-for-v4.1/wl12xx-dt' of git://git.kernel.org/pub/scm/linux/kernel/git/tmlind/linux-omap:
  wlcore: remove wl12xx_platform_data
  ARM: dts: add wl12xx/wl18xx bindings
  wlcore: add device-tree support
  dt: bindings: add TI's wilink wireless device
  wl12xx: use frequency instead of enumerations for pdata clocks
  wlcore: set irq_trigger in board files instead of hiding behind a quirk
  + Linux 4.0-rc4

Signed-off-by: Olof Johansson <olof@lixom.net>

7 files changed, 46 insertions, 11 deletions

diff --git a/drivers/spi/spi-atmel.c b/drivers/spi/spi-atmel.c
index 9af7841f2e8c..06de34001c66 100644
--- a/drivers/spi/spi-atmel.c
+++ b/drivers/spi/spi-atmel.c
@@ -764,17 +764,17 @@ static void atmel_spi_pdc_next_xfer(struct spi_master *master,
 			(unsigned long long)xfer->rx_dma);
 	}
 
-	/* REVISIT: We're waiting for ENDRX before we start the next
+	/* REVISIT: We're waiting for RXBUFF before we start the next
 	 * transfer because we need to handle some difficult timing
-	 * issues otherwise. If we wait for ENDTX in one transfer and
-	 * then starts waiting for ENDRX in the next, it's difficult
-	 * to tell the difference between the ENDRX interrupt we're
-	 * actually waiting for and the ENDRX interrupt of the
+	 * issues otherwise. If we wait for TXBUFE in one transfer and
+	 * then starts waiting for RXBUFF in the next, it's difficult
+	 * to tell the difference between the RXBUFF interrupt we're
+	 * actually waiting for and the RXBUFF interrupt of the
 	 * previous transfer.
 	 *
 	 * It should be doable, though. Just not now...
 	 */
-	spi_writel(as, IER, SPI_BIT(ENDRX) | SPI_BIT(OVRES));
+	spi_writel(as, IER, SPI_BIT(RXBUFF) | SPI_BIT(OVRES));
 	spi_writel(as, PTCR, SPI_BIT(TXTEN) | SPI_BIT(RXTEN));
 }
 
diff --git a/drivers/spi/spi-dw-mid.c b/drivers/spi/spi-dw-mid.c
index a0197fd4e95c..3ce39d10fafb 100644
--- a/drivers/spi/spi-dw-mid.c
+++ b/drivers/spi/spi-dw-mid.c
@@ -139,6 +139,9 @@ static struct dma_async_tx_descriptor *dw_spi_dma_prepare_tx(struct dw_spi *dws)
 				1,
 				DMA_MEM_TO_DEV,
 				DMA_PREP_INTERRUPT | DMA_CTRL_ACK);
+	if (!txdesc)
+		return NULL;
+
 	txdesc->callback = dw_spi_dma_tx_done;
 	txdesc->callback_param = dws;
 
@@ -184,6 +187,9 @@ static struct dma_async_tx_descriptor *dw_spi_dma_prepare_rx(struct dw_spi *dws)
 				1,
 				DMA_DEV_TO_MEM,
 				DMA_PREP_INTERRUPT | DMA_CTRL_ACK);
+	if (!rxdesc)
+		return NULL;
+
 	rxdesc->callback = dw_spi_dma_rx_done;
 	rxdesc->callback_param = dws;
 
diff --git a/drivers/spi/spi-dw-pci.c b/drivers/spi/spi-dw-pci.c
index 5ba331047cbe..6d331e0db331 100644
--- a/drivers/spi/spi-dw-pci.c
+++ b/drivers/spi/spi-dw-pci.c
@@ -36,13 +36,13 @@ struct spi_pci_desc {
 
 static struct spi_pci_desc spi_pci_mid_desc_1 = {
 	.setup = dw_spi_mid_init,
-	.num_cs = 32,
+	.num_cs = 5,
 	.bus_num = 0,
 };
 
 static struct spi_pci_desc spi_pci_mid_desc_2 = {
 	.setup = dw_spi_mid_init,
-	.num_cs = 4,
+	.num_cs = 2,
 	.bus_num = 1,
 };
 
diff --git a/drivers/spi/spi-dw.c b/drivers/spi/spi-dw.c
index 5a97a62b298a..4847afba89f4 100644
--- a/drivers/spi/spi-dw.c
+++ b/drivers/spi/spi-dw.c
@@ -621,14 +621,14 @@ static void spi_hw_init(struct device *dev, struct dw_spi *dws)
 	if (!dws->fifo_len) {
 		u32 fifo;
 
-		for (fifo = 2; fifo <= 256; fifo++) {
+		for (fifo = 1; fifo < 256; fifo++) {
 			dw_writew(dws, DW_SPI_TXFLTR, fifo);
 			if (fifo != dw_readw(dws, DW_SPI_TXFLTR))
 				break;
 		}
 		dw_writew(dws, DW_SPI_TXFLTR, 0);
 
-		dws->fifo_len = (fifo == 2) ? 0 : fifo - 1;
+		dws->fifo_len = (fifo == 1) ? 0 : fifo;
 		dev_dbg(dev, "Detected FIFO size: %u bytes\n", dws->fifo_len);
 	}
 }
diff --git a/drivers/spi/spi-img-spfi.c b/drivers/spi/spi-img-spfi.c
index c01567d53581..e649bc7d4c08 100644
--- a/drivers/spi/spi-img-spfi.c
+++ b/drivers/spi/spi-img-spfi.c
@@ -459,6 +459,13 @@ static int img_spfi_transfer_one(struct spi_master *master,
 	unsigned long flags;
 	int ret;
 
+	if (xfer->len > SPFI_TRANSACTION_TSIZE_MASK) {
+		dev_err(spfi->dev,
+			"Transfer length (%d) is greater than the max supported (%d)",
+			xfer->len, SPFI_TRANSACTION_TSIZE_MASK);
+		return -EINVAL;
+	}
+
 	/*
 	 * Stop all DMA and reset the controller if the previous transaction
 	 * timed-out and never completed it's DMA.
diff --git a/drivers/spi/spi-pl022.c b/drivers/spi/spi-pl022.c
index 89ca162801da..ee513a85296b 100644
--- a/drivers/spi/spi-pl022.c
+++ b/drivers/spi/spi-pl022.c
@@ -534,12 +534,12 @@ static void giveback(struct pl022 *pl022)
 	pl022->cur_msg = NULL;
 	pl022->cur_transfer = NULL;
 	pl022->cur_chip = NULL;
-	spi_finalize_current_message(pl022->master);
 
 	/* disable the SPI/SSP operation */
 	writew((readw(SSP_CR1(pl022->virtbase)) &
 		(~SSP_CR1_MASK_SSE)), SSP_CR1(pl022->virtbase));
 
+	spi_finalize_current_message(pl022->master);
 }
 
 /**
diff --git a/drivers/spi/spi-ti-qspi.c b/drivers/spi/spi-ti-qspi.c
index 884a716e50cb..5c0616870358 100644
--- a/drivers/spi/spi-ti-qspi.c
+++ b/drivers/spi/spi-ti-qspi.c
@@ -101,6 +101,7 @@ struct ti_qspi {
 #define QSPI_FLEN(n)			((n - 1) << 0)
 
 /* STATUS REGISTER */
+#define BUSY				0x01
 #define WC				0x02
 
 /* INTERRUPT REGISTER */
@@ -199,6 +200,21 @@ static void ti_qspi_restore_ctx(struct ti_qspi *qspi)
 	ti_qspi_write(qspi, ctx_reg->clkctrl, QSPI_SPI_CLOCK_CNTRL_REG);
 }
 
+static inline u32 qspi_is_busy(struct ti_qspi *qspi)
+{
+	u32 stat;
+	unsigned long timeout = jiffies + QSPI_COMPLETION_TIMEOUT;
+
+	stat = ti_qspi_read(qspi, QSPI_SPI_STATUS_REG);
+	while ((stat & BUSY) && time_after(timeout, jiffies)) {
+		cpu_relax();
+		stat = ti_qspi_read(qspi, QSPI_SPI_STATUS_REG);
+	}
+
+	WARN(stat & BUSY, "qspi busy\n");
+	return stat & BUSY;
+}
+
 static int qspi_write_msg(struct ti_qspi *qspi, struct spi_transfer *t)
 {
 	int wlen, count;
@@ -211,6 +227,9 @@ static int qspi_write_msg(struct ti_qspi *qspi, struct spi_transfer *t)
 	wlen = t->bits_per_word >> 3;	/* in bytes */
 
 	while (count) {
+		if (qspi_is_busy(qspi))
+			return -EBUSY;
+
 		switch (wlen) {
 		case 1:
 			dev_dbg(qspi->dev, "tx cmd %08x dc %08x data %02x\n",
@@ -266,6 +285,9 @@ static int qspi_read_msg(struct ti_qspi *qspi, struct spi_transfer *t)
 
 	while (count) {
 		dev_dbg(qspi->dev, "rx cmd %08x dc %08x\n", cmd, qspi->dc);
+		if (qspi_is_busy(qspi))
+			return -EBUSY;
+
 		ti_qspi_write(qspi, cmd, QSPI_SPI_CMD_REG);
 		if (!wait_for_completion_timeout(&qspi->transfer_complete,
 						 QSPI_COMPLETION_TIMEOUT)) {