serial: zs: Switch to using channel reset

Switch the driver to using the channel reset rather than hardware reset,
simplifying handling by removing an interference between channels that
causes the other channel to become uninitialised afterwards.

There is little difference between the two kinds of reset in terms of
register settings that result, and we initialise the whole register set
right away anyway.  However this prevents a hang from happening should
the console output handler in the firmware try to access the other port
whose transmitter has been disabled and line parameters messed up.

For example this will happen if the keyboard port (port A) is chosen for
the system console, unusually but not insanely for a headless system, as
the port is wired to a standard DA-15 connector and an adapter can be
easily made.  Or with the next change in place this would happen for the
regular console port (port B), since the keyboard port (port A) will be
initialised first.

Just remove the unnecessary complication then, a channel reset is good
enough.  We still need the initialisation marker, now per channel rather
than per SCC, as for the console port zs_reset() will be called twice:
once early on via zs_serial_console_init() for the console setup only,
and then again via zs_config_port() as the port is associated with a TTY
device.

Fixes: 8b4a40809e53 ("zs: move to the serial subsystem")
Signed-off-by: Maciej W. Rozycki <macro@orcam.me.uk>
Cc: stable@vger.kernel.org # v2.6.23+
Link: https://patch.msgid.link/alpine.DEB.2.21.2605062323430.46195@angie.orcam.me.uk
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

0 files changed, 0 insertions, 0 deletions