Bluetooth: hci_qca: Do not write to the serial port after it is closed

hci_uart_close() closes the serdev port if HCI_QUIRK_NON_PERSISTENT_SETUP
is set (for example, for the WCN399x family). A failed hci_dev_open_sync()
following a successful qca_setup() calls hdev->close() but not
hdev->shutdown(), so the port is closed while power->vregs_on is left true.
qca_serdev_remove() then passes its power->vregs_on test and calls
qca_power_off(), which writes to the closed port unconditionally.

Seen on a WCN3988 by unbinding the driver after a controller failure. The
trace below is from a 7.0.0 based kernel, where qca_power_off() was still
named qca_power_shutdown():

  Unable to handle kernel NULL pointer dereference at virtual address
  0000000000000038
  Call trace:
   tty_set_termios+0x50/0x238 (P)
   ttyport_set_baudrate+0x84/0xc0
   serdev_device_set_baudrate+0x24/0x40
   qca_power_shutdown+0x158/0x1fc [hci_uart]
   qca_serdev_remove+0x54/0x68 [hci_uart]
   serdev_drv_remove+0x1c/0x2c
   device_remove+0x4c/0x80
   device_release_driver_internal+0x1cc/0x224
   device_driver_detach+0x18/0x24
   unbind_store+0xb4/0xc0

Check HCI_UART_PROTO_READY, which hci_uart_close() clears in the same place
it closes the port, before writing to it. The regulator disable is left
unconditional so the controller is still powered down.

The dangling serport->tty that turns this into a use-after-free is
addressed in a separate patch.

Fixes: fa9ad876b8e0 ("Bluetooth: hci_qca: Add support for Qualcomm Bluetooth chip wcn3990")
Signed-off-by: Ibrahim Abdelkader <iabdelka@qti.qualcomm.com>
Reviewed-by: Hans de Goede <johannes.goede@oss.qualcomm.com>
Signed-off-by: Hans de Goede <johannes.goede@oss.qualcomm.com>
Signed-off-by: Luiz Augusto von Dentz <luiz.von.dentz@intel.com>

0 files changed, 0 insertions, 0 deletions