regulator: ab8500: Add buck converter support

Register the SMPS1, SMPS2, SMPS3, ARM, APE and MOD buck converters on
AB8500 and the VSMPSA, VSMPSB, VSAFE, VARM, VSMPSC and VSMPSM buck
converters on AB8505 so that the new device tree nodes can supply
consumers. Match each variant through its own device tree node names.

AB8500 SMPS3 supplies Vsafe and AB8505 VSAFE occupies the corresponding
control and selector registers at 0x0405 and 0x041b through 0x041d.
AB8500 VAPE and AB8505 VSMPSC instead use 0x0402 and the 0x040e through
0x0410 selector registers. Keep separate AB8505 regulator descriptors
and identifiers so these variant-specific rails are not conflated.

Describe the hardware selector ranges and follow the selector-control
registers when reading or changing voltage. This accounts for AB8505
using Sel2 after reset, its additional selector registers and its
separate 7-bit VARM range. Use the AB8500-compatible and low-range OTP
profiles found on the supported platforms for the other rails.

SMPS1 through SMPS3 and VSMPSA, VSMPSB and VSAFE also expose enable and
low-power mode control. Keep the ARM, APE, MOD, VARM, VSMPSC and VSMPSM
rails voltage-only since their on/off state is managed with the SoC.

Assisted-by: LLM
Signed-off-by: Linus Walleij <linusw@kernel.org>
Link: https://patch.msgid.link/20260901-ux500-dts-snowball-regulator-v2-9-fe88b01829bf@kernel.org
Signed-off-by: Mark Brown <broonie@kernel.org>

0 files changed, 0 insertions, 0 deletions