Merge branch '2021-07-07-remove-non-migrated-platforms'

- Remove a large number of platforms that did not migrate to DM_PCI or
  DM_USB by 2 years past the migration deadline and do not have a
  migration imminent.

1 files changed, 0 insertions, 49 deletions

diff --git a/drivers/mtd/nand/raw/fsmc_nand.c b/drivers/mtd/nand/raw/fsmc_nand.c
index 1f4c74f0f63..1c24710b2db 100644
--- a/drivers/mtd/nand/raw/fsmc_nand.c
+++ b/drivers/mtd/nand/raw/fsmc_nand.c
@@ -389,55 +389,6 @@ static int fsmc_read_page_hwecc(struct mtd_info *mtd, struct nand_chip *chip,
 	return 0;
 }
 
-#ifndef CONFIG_SPL_BUILD
-/*
- * fsmc_nand_switch_ecc - switch the ECC operation between different engines
- *
- * @eccstrength		- the number of bits that could be corrected
- *			  (1 - HW, 4 - SW BCH4)
- */
-int fsmc_nand_switch_ecc(uint32_t eccstrength)
-{
-	struct nand_chip *nand;
-	struct mtd_info *mtd;
-	int err;
-
-	/*
-	 * This functions is only called on SPEAr600 platforms, supporting
-	 * 1 bit HW ECC. The BCH8 HW ECC (FSMC_VER8) from the ST-Ericsson
-	 * Nomadik SoC is currently supporting this fsmc_nand_switch_ecc()
-	 * function, as it doesn't need to switch to a different ECC layout.
-	 */
-	mtd = get_nand_dev_by_index(nand_curr_device);
-	nand = mtd_to_nand(mtd);
-
-	/* Setup the ecc configurations again */
-	if (eccstrength == 1) {
-		nand->ecc.mode = NAND_ECC_HW;
-		nand->ecc.bytes = 3;
-		nand->ecc.strength = 1;
-		nand->ecc.layout = &fsmc_ecc1_layout;
-		nand->ecc.calculate = fsmc_read_hwecc;
-		nand->ecc.correct = nand_correct_data;
-	} else if (eccstrength == 4) {
-		/*
-		 * .calculate .correct and .bytes will be set in
-		 * nand_scan_tail()
-		 */
-		nand->ecc.mode = NAND_ECC_SOFT_BCH;
-		nand->ecc.strength = 4;
-		nand->ecc.layout = NULL;
-	} else {
-		printf("Error: ECC strength %d not supported!\n", eccstrength);
-	}
-
-	/* Update NAND handling after ECC mode switch */
-	err = nand_scan_tail(mtd);
-
-	return err;
-}
-#endif /* CONFIG_SPL_BUILD */
-
 int fsmc_nand_init(struct nand_chip *nand)
 {
 	static int chip_nr;