1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
91
92
93
94
95
96
97
98
99
100
101
102
103
104
105
106
107
108
109
110
111
112
113
114
115
116
117
118
119
120
121
122
123
124
125
126
127
128
129
130
131
132
133
134
135
136
137
138
139
140
141
142
143
144
145
146
147
148
149
150
151
152
153
154
155
156
157
158
159
160
161
162
163
164
165
166
167
168
169
170
171
172
173
174
175
176
177
178
179
180
181
182
183
184
185
186
187
188
189
190
191
192
193
194
195
196
197
198
199
200
|
// SPDX-License-Identifier: GPL-2.0
/*
* AM642: SoC specific initialization
*
* Copyright (C) 2020-2021 Texas Instruments Incorporated - https://www.ti.com/
* Keerthy <j-keerthy@ti.com>
* Dave Gerlach <d-gerlach@ti.com>
*/
#include <common.h>
#include <spl.h>
#include <asm/io.h>
#include <asm/arch/hardware.h>
#include <asm/arch/sysfw-loader.h>
#include <asm/arch/sys_proto.h>
#include "common.h"
#include <asm/arch/sys_proto.h>
#include <linux/soc/ti/ti_sci_protocol.h>
#include <dm.h>
#include <dm/uclass-internal.h>
#include <dm/pinctrl.h>
#if defined(CONFIG_SPL_BUILD)
static void ctrl_mmr_unlock(void)
{
/* Unlock all PADCFG_MMR1 module registers */
mmr_unlock(PADCFG_MMR1_BASE, 1);
/* Unlock all CTRL_MMR0 module registers */
mmr_unlock(CTRL_MMR0_BASE, 0);
mmr_unlock(CTRL_MMR0_BASE, 1);
mmr_unlock(CTRL_MMR0_BASE, 2);
mmr_unlock(CTRL_MMR0_BASE, 3);
mmr_unlock(CTRL_MMR0_BASE, 5);
mmr_unlock(CTRL_MMR0_BASE, 6);
}
/*
* This uninitialized global variable would normal end up in the .bss section,
* but the .bss is cleared between writing and reading this variable, so move
* it to the .data section.
*/
u32 bootindex __section(".data");
static struct rom_extended_boot_data bootdata __section(.data);
static void store_boot_info_from_rom(void)
{
bootindex = *(u32 *)(CONFIG_SYS_K3_BOOT_PARAM_TABLE_INDEX);
memcpy(&bootdata, (uintptr_t *)ROM_ENTENDED_BOOT_DATA_INFO,
sizeof(struct rom_extended_boot_data));
}
void board_init_f(ulong dummy)
{
#if defined(CONFIG_K3_LOAD_SYSFW)
struct udevice *dev;
int ret;
#endif
#if defined(CONFIG_CPU_V7R)
setup_k3_mpu_regions();
#endif
/*
* Cannot delay this further as there is a chance that
* K3_BOOT_PARAM_TABLE_INDEX can be over written by SPL MALLOC section.
*/
store_boot_info_from_rom();
ctrl_mmr_unlock();
/* Init DM early */
spl_early_init();
preloader_console_init();
#if defined(CONFIG_K3_LOAD_SYSFW)
/*
* Process pinctrl for serial3 a.k.a. MAIN UART1 module and continue
* regardless of the result of pinctrl. Do this without probing the
* device, but instead by searching the device that would request the
* given sequence number if probed. The UART will be used by the system
* firmware (SYSFW) image for various purposes and SYSFW depends on us
* to initialize its pin settings.
*/
ret = uclass_find_device_by_seq(UCLASS_SERIAL, 3, &dev);
if (!ret)
pinctrl_select_state(dev, "default");
/*
* Load, start up, and configure system controller firmware.
* This will determine whether or not ROM has already loaded
* system firmware and if so, will only perform needed config
* and not attempt to load firmware again.
*/
k3_sysfw_loader(is_rom_loaded_sysfw(&bootdata), NULL, NULL);
#endif
/* Output System Firmware version info */
k3_sysfw_print_ver();
}
u32 spl_boot_mode(const u32 boot_device)
{
switch (boot_device) {
case BOOT_DEVICE_MMC1:
return MMCSD_MODE_EMMCBOOT;
case BOOT_DEVICE_MMC2:
return MMCSD_MODE_FS;
default:
return MMCSD_MODE_RAW;
}
}
static u32 __get_backup_bootmedia(u32 main_devstat)
{
u32 bkup_bootmode =
(main_devstat & MAIN_DEVSTAT_BACKUP_BOOTMODE_MASK) >>
MAIN_DEVSTAT_BACKUP_BOOTMODE_SHIFT;
u32 bkup_bootmode_cfg =
(main_devstat & MAIN_DEVSTAT_BACKUP_BOOTMODE_CFG_MASK) >>
MAIN_DEVSTAT_BACKUP_BOOTMODE_CFG_SHIFT;
switch (bkup_bootmode) {
case BACKUP_BOOT_DEVICE_UART:
return BOOT_DEVICE_UART;
case BACKUP_BOOT_DEVICE_USB:
return BOOT_DEVICE_USB;
case BACKUP_BOOT_DEVICE_ETHERNET:
return BOOT_DEVICE_ETHERNET;
case BACKUP_BOOT_DEVICE_MMC:
if (bkup_bootmode_cfg)
return BOOT_DEVICE_MMC2;
return BOOT_DEVICE_MMC1;
case BACKUP_BOOT_DEVICE_SPI:
return BOOT_DEVICE_SPI;
case BACKUP_BOOT_DEVICE_I2C:
return BOOT_DEVICE_I2C;
};
return BOOT_DEVICE_RAM;
}
static u32 __get_primary_bootmedia(u32 main_devstat)
{
u32 bootmode = (main_devstat & MAIN_DEVSTAT_PRIMARY_BOOTMODE_MASK) >>
MAIN_DEVSTAT_PRIMARY_BOOTMODE_SHIFT;
u32 bootmode_cfg =
(main_devstat & MAIN_DEVSTAT_PRIMARY_BOOTMODE_CFG_MASK) >>
MAIN_DEVSTAT_PRIMARY_BOOTMODE_CFG_SHIFT;
switch (bootmode) {
case BOOT_DEVICE_OSPI:
fallthrough;
case BOOT_DEVICE_QSPI:
fallthrough;
case BOOT_DEVICE_XSPI:
fallthrough;
case BOOT_DEVICE_SPI:
return BOOT_DEVICE_SPI;
case BOOT_DEVICE_ETHERNET_RGMII:
fallthrough;
case BOOT_DEVICE_ETHERNET_RMII:
return BOOT_DEVICE_ETHERNET;
case BOOT_DEVICE_EMMC:
return BOOT_DEVICE_MMC1;
case BOOT_DEVICE_MMC:
if ((bootmode_cfg & MAIN_DEVSTAT_PRIMARY_MMC_PORT_MASK) >>
MAIN_DEVSTAT_PRIMARY_MMC_PORT_SHIFT)
return BOOT_DEVICE_MMC2;
return BOOT_DEVICE_MMC1;
case BOOT_DEVICE_NOBOOT:
return BOOT_DEVICE_RAM;
}
return bootmode;
}
u32 spl_boot_device(void)
{
u32 devstat = readl(CTRLMMR_MAIN_DEVSTAT);
if (bootindex == K3_PRIMARY_BOOTMODE)
return __get_primary_bootmedia(devstat);
else
return __get_backup_bootmedia(devstat);
}
#endif
|
