blob: a1f526fd4cca473e7c1b3d28cb82773110c0e9a4 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
|
.. SPDX-License-Identifier: GPL-2.0+
imx93_frdm
==========
U-Boot for the NXP i.MX93 FRDM board
Quick Start
-----------
- Get and Build the ARM Trusted firmware
- Get the DDR firmware
- Get ahab-container.img
- Build U-Boot
- Boot from the SD card
Get and Build the ARM Trusted firmware
--------------------------------------
Note: srctree is U-Boot source directory
Get ATF from: https://github.com/nxp-imx/imx-atf/
branch: lf_v2.8
.. code-block:: bash
$ unset LDFLAGS
$ make PLAT=imx93 bl31
$ cp build/imx93/release/bl31.bin $(srctree)
Get the DDR firmware
--------------------
.. code-block:: bash
$ wget https://www.nxp.com/lgfiles/NMG/MAD/YOCTO/firmware-imx-8.21.bin
$ chmod +x firmware-imx-8.21.bin
$ ./firmware-imx-8.21.bin
$ cp firmware-imx-8.21/firmware/ddr/synopsys/lpddr4*.bin $(srctree)
Get ahab-container.img
----------------------
.. code-block:: bash
$ wget https://www.nxp.com/lgfiles/NMG/MAD/YOCTO/firmware-sentinel-0.11.bin
$ chmod +x firmware-sentinel-0.11.bin
$ ./firmware-sentinel-0.11.bin
$ cp firmware-sentinel-0.11/mx93a1-ahab-container.img $(srctree)
Build U-Boot
------------
.. code-block:: bash
$ export CROSS_COMPILE=aarch64-poky-linux-
$ make imx93_frdm_defconfig
$ make
Copy the flash.bin binary to the MicroSD card at offset 32KB:
.. code-block:: bash
$ dd if=flash.bin of=/dev/sd[x] bs=1k seek=32; sync
Boot from the SD card
---------------------
- Configure SW1 boot switches to SD boot mode:
0011 SW1[3:0] - ("USDHC2 4-bit SD3.0" Boot Mode)
- Insert the SD card in the SD slot (P13) of the board.
- Connect a USB Type-C cable into the P16 Debug USB Port and connect
using a terminal emulator at 115200 bps, 8n1. The console will show up
at /dev/ttyACM0.
- Power on the board by connecting a USB Type-C cable into the P1
Power USB Port.
|
